Metra AX-TOYUSB-2 2010-Up Toyota USB Adaptor

This works for my tundra usb/aux connector below the climate control. It connects from back of stereo to a metal box behind the glove box area. Instructions are to remove glove box but I was able to pull bottom covers below glove box and reach up to connect this. Tight fit but beats pulling all the glove box items out.

Worked perfectly in my 2012 Highlander Hybrid. I replaced the factory navigation system with an aftermarket head-unit, but I wanted to keep the existing Toyota USB/Aux receptacle on the dash. This cable enabled me to connect Toyota receptacle to regular USB socket on rear of new head-unit.As other reviewers have noted, to use this cable, you have to unplug the Toyota cable at its far end, which is tricky to find and then disconnect. The first photo shows the Toyota cable: the left-hand connector plugs into the back of the USB & Aux receptacle. Leave this plugged in. The cable splits into two, with the USB half going to a box just behind the radio (I think this is called the MMI unit). You need to unplug this brown connector (right-hand side of first photo), and plug it into the AX-TOYUSB-2 receptacle (second photo).Clearly, not too hard, but it would be helpful if there were some instructions. I think some of the people who bought this have assumed that it is supposed to plug directly into the Toyota dashboard receptacle.

Waste of money for a 2010 Toyota SR5 Tundra Extended Cab. Not even close to the connector of the native in dash USB plug. I tried to modify it and it's now in the garbage - because it won't work.

Good.

Worked perfect to keep my Tundra oem usb plug in the dash. People have stated that this adapter does not fit, they are wrong. It does not plug in behind the usb port on dash.. you must take both glove boxes out to find correct location. After glove box is out, look to the left and you will see a small metal box with 3 sets of wires running to it, one is the brown plug you need. Just connect that brown plug with your new adapter, run the other end to your usb port on aftermarket radio! Perfect! Found it on all tundras 2008 through 2015. Check yours before ou buy it, but it works perfectly and I did not have to rig or cut anything...

IS NOT COMPATIBLE with factory 2013 Toyota Sequoia USB/AUX w/o JBL/Navigation.Update. After reading other peoples reviews, I discovered that IT IS compatible. However, you have to remove the glove box and air bag to get to the point it’s supposed to plug in to. Only giving this three stars because even though it works, there are zero instructions on how to install this thing. As noted above I had to read other peoples reviews for instructions. Also, I don’t know why it can’t simply plug into the factory USB port/factory wiring harness. This would make it much easier and far less time-consuming and frustrating.

Item was received as described. Thank you.

Works great. Read the reviews that discribe where to hook this up behind the glove box. No need to remove glove boxes on 2012 Tundra. Just remove the kick panel under the glove box and look up near the center console. The metal box will have the cable connected to it that you need to unplug and then connect to new Metra cable.

I installed this adapter and it does just as described... connects the factory plug to the female USB port from my new aftermarket deck.Before buying this though, ask yourself if you will use that factory USB port. I hooked it up, then realized I don't like using the port in it's current location. That's me though. The product works just fine.

Good product plugged right in.

Product looks good except they keep giving me the wrong one

worked

Good product