MPD Digital I LMR400 Ultraflex Times Microwave Coax Cable I Threaded on Soldered PL259 to PL259 UHF Connectors I Low Loss I CB Ham Radio, Hotspot WiFi, Radio Transmitters, Antenna I 4 FT

Excellent cable... I run 1000 watts regularly and for extended time. No problem at all. The end connectors are top quality.

Good quality coax jumper.

Using it as a jumper between the wall and radio and it works great. Solid build. Good connectors.

I ordered 5 of these 5ft cables to use as patch cables between my tuner and radios.All seemed good at first but after a few weeks, I began to notice higher and higher SWR readings. After careful analysis and replacing several other parts, I finally replaced these cables with other patch cables that I had on-hand. SWR problems went away. I am an Extra Class Ham Radio operator and use a quality analyzer but the problem with these cables has yet to be determined. They just don't seem to hold up and work for any length of time.

I am impressed with these coax jumpers. They perform well and are durable. They are able to bend in a fairly tight 90 degree turn without breaking the center conductor.

Used as patch cables for ham radio 2m & 70cm

Exactly what I was looking for. Good quality cable.

I decided to standardize on LMR and aside from a little extra expense and hassle working with the larger diameter, it has been worth it. These pre-built cables eliminate the hassle of soldering your own connectors... an art that I've never quite mastered. Out of a dozen or so pre-built cables I've only had one connector come loose, probably my fault for hanging it 60' vertically from a dipole and exposing it to high wind :/