90 Degree Adjustable 3 Pin XLR Right Angle Connector - 7 Clockable Positions (Female)

For a clockable XLR ( the connector can set to different positions) the build quality is very good, I have a few of the these and no problems.

Perfect for making custom audio cables.The right angle allows me to install my Yamaha CX-A5100 11.2-CH MusicCast Preamplifier home theater AV receiver in a tight place that couldn't be done with standard straight XLR connectors. The multi-angle custom positioning is GREAT. Construction is top notch and includes a rubber gasket sealing ring that makes a perfect fit to the preamp eliminating any loose connection... a nice touch that's a cut above the rest. Works well with professional 1/4" (6mm) audio cable.If you're good with a soldering iron and want to make your own awesome custom audio cables, these will definitely be up to the task. Works well with professional 1/4" (6mm) 2 conductor shielded audio cable.

Pride mobility scooters are great but they require you to get to ground level to charge the battery, and the folks who need the scooters are often unable to bend down to do that. So they use short extension cables plugged into the battery so that they can bring the charge port up where they can reach it. Great idea, right?But the problem now is that the extension cable is near their feet and it gets kicked around often damaging the battery port or the extension cable connector. Well, the solution to that is swapping the end that plugs into the battery with these right angle connectors. They plug in flush against the battery and the cable can be routed out of the way of their feet. Anyway I've fixed two scooters using these connectors and they are working fine.I like the way the wire is guided through the strain relief to the connectors and the method they use to allow you to select the angle at which you want the wires to leave the connector when it is plugged in. It allowed me to customize the cable to best route the wire out of the way of the rider's feet.

The right angle allowed enough clearance for a cover on the device where they were used. The seven possible rotation positions allowed the wires to be kept out of the way of other cords.

Adjusts to a variety of angles. I gave only 4 stars because the cover is held by two screws at one end: good in a studio; but on the road, one would need to be careful the cover is not pulled off.

Works great for a connection into my DMX lighting controller in a tight spot and to set in the direction I need to save space in my rack without blocking other switches/connectors.

Awesome, had to replace the connector on my shotgun mic and ordered this. Was easy to install and love the fact I was able to adjust it to fit the space I had to work with.

The swivel on it works well with my berhinger mixer .which is always in its case and I do not have to disconnect it from my crossover