Lenox Speed Slot 1772954 Hole Saw, 2-1/2 in Dia, 1-1/2 in D Cutting, HSS Cutting Edge

Good quality hole saw. Works as it should. Cut a couple dozen holes for organizing 2 1/2" dust collection fittings.

Used this to cut a hole in the dash of the bridge on my boat for tilt switches. It worked very fast and left a clean and precise hole even in the fiberglass. So it’s very accurate. Blade stayed sharp throughout the project and I still use it. Fit perfect in my Ryobi cordless drill. Great price for functionality.

I used this to cut holes in melamine boards. I put some tape on the front side of the board and backed the boards with some scrap wood to prevent breakout on the reverse side and it did a great job cutting the holes out cleanly even on melamine. This cutter seems to have more teeth than some of the others I've seen so I'm guessing it cuts slower but more cleanly. To be clear, this is the only hole cutter I have as I purchased this for a specific project, but it did what I wanted well.

Bought two sizes. Have a project that requires a hole saw, used with the drill press, and it made its way thru, although it was a challenge with white oak. Slow is the key ....

Well made will stand up to professional use

This hole saw cut thru the steel plate floor like BUTTER. Fast. Not bad cost. Great quality. Recommended.

Picked this up to install my mini-split in my garage. This is the second LENOX hole saw I've picked up and they are good quality saws. As others have mentioned, be sure to tighten it up or it can spin off when you stop drilling.

Works like a charm. Great buy, considering it comes with the pilot drill attachment. Used it for cutting multiple holes in 1/2 plywood. After some use, I was able to get the plug to just drop off without any prying. Seemed the easier/slower I made the cut, the more likely I was able to just run the drill for a few seconds after the cut and the plug will fall out (3 out of 5 times). High quality product. Will likely purchase other sizes as need in the future.

It works very well. It is professional tool.

I had been using a Benchmark hole saw and although it was fine for the thin layer of metal, it did not work for the thicker, so I ordered the Lenox hole saw and it finished the job in less than a minute. I should have ordered the Lenox to start with. Very pleased.

Went right through the wall no problem.

Quality tools make works so easy. Cut through wood like butter.

Bought the cheapo ikea one for their led puck lights. Took 5 minutes of smelly dusty cutting to break through my cabinets. Bought the Lenox. Did the job in 20 seconds, cleaner and with less dust. Highly recommend.