Nilight - JK-61A 2" inch Rear Bumper Tow Trailer Hitch Receiver Kit, Compatible for 2007-2018 Jeep Wrangler JK 4 Door & 2 Unlimited, w/4-Pin Wiring Harness (Exclude JL Models)

I'm going to take away one star for a documentation miss, but I will definitely recommend this.I have a 2015 Rubicon Hard Rock edition with the steel rear bumper.In this case, you do not use the provided 3/4" hardware.You'll remove the four bolts(18mm heads) at the back of the chassis that thread into the steel bumper. A one foot metal spacer shim will fall out from between the chassis and bumper. The hitch will slide right up into place and you'll replace the original bolts. Easy.The kit is complete.The instructions have really small print and the images could be improved.Overall, a simple install. Took me 45 min to route the wires(15min) and install the hitch(30min).Would highly recommend.

Great product, very good quality and easy to install. I was able to install without removing anything from the jeep. Took some determination and small hands to get the washers and nuts on but didn’t need to remove anything. Looks great! Would recommend.

Fit and finish are great. Works with my aftermarket bumper just fine.Didn't use the writing harness, so I have nothing to say about that.

Awesome hitch, good quality and very easy to install. Comes with all the parts needed to hook up.

A very high quality hitch that came with everything necessary to install. Installation start to finish took me under 30 minutes.I didn’t remove the bumper cover, having previously glued the lock washer to the washer before pushing the bolts in from the back. Once the washers were on the bolts, I taped the nut to a 19mm open end wrench and slipped it up to the bolt. A bit tricky, but doable. Use a short 19mm socket on the muffler side of the frame rail.The taillight is taken off by removing the four Phillips head screws. Note that the lens doesn’t come off the taillight bucket, the entire assembly comes off. Unplug the wiring, connect the plug in the included wire harness, run the other end down and out at the bottom and reinstall the taillight. Carefully route the harness to the trailer hitch, avoiding the muffler. The included cable ties didn’t fit the existing holes in the frame, so I used my own. That’s it!

The fitment is a bit larger than the frame it attaches to, but once everything is on and snug, its good to go. I ended up using a washer to fill some of the difference.Wiring harness could do with a few more zip ties.Keep in mind, this isn't gonna be a 8k lb hitch, but for towing a 2-3k lb trailer, its served me fine.

Easy to install. Great fit

Great product for the price and easy to install