16" Table Saw Extension Kit PW1007

The plans are really more of a suggestion of a possible way to build this.I had to redesign so many parts of the plan that most of it was changedAdditionally most of the hardware might work on some table saws buton my Delta 10" contractor saw I was able to only use the 2 24" t-track and 2of the 4 knobs. I would not buy the kit again.If you really want to build this extension (it is a good idea and I was able toget it to work) just buy the plans and then modify them to work for your saw.Most likely you will have to do a lot of modifications for your specific saw anyway. Save the 40.00 bucks for the kit and just get the plans. Build something similar on your own. Also why did they request a 1.5 inch table top for the outfeed thatisn't required? I just used shims on the supports and a 3/4 inch top.Using 3/4 is much lighter and easier to deal with.By using shims I can more precisely level the outfeed table and it is muchlighter when I want to move it.I gave it 2 stars because the idea is good. The plan gives you a starting pointbut the kit itself is not very helpful I have most of the parts left on the floor.

Instructions were bad and from the instructions I didn't receiver all the parts.

No viene completo