3000 FLEX 50 Dual Temp Corded PUR Hot Melt Applicator for 50 Gram Cartridges

This glue is not really meant for your entire project assuming it is a large one for small projects you can use this for every joint but the things that you would use this glue gun for it works amazingly once you figure out how to use it. I use it for my end grain miter joints you first need to make sure that they are capless and seamless then apply a small amount to one side put your miter together move it back and forth Just slightly until the glue starts to set and then push it into a square and hold for a moment and you will have a miter joint that is ready for sanding and continued work but don't think that you're going to be able to paint this glue like regular wood glue and the paint stick because it won't miter needs to be tight

I use this product for extremely strong joints. I build a lot of handrails. Peoples safety is paramount. In the past I would use wood glue and nails. This uses a hot polyurethane melt to create a peerless bond. I now don't have to use finish nails. The appearance of the finished product is far superior than before and also the durability is on another level. It is especially useful with projects when nothing else will work and you need a professional tool.

The heater barrel attaches using a ’bayonette’ style breech mechanism. Unfortunately there is no positive latching so the barrel containing the adhesive cartridge twists and falls off. Really bad in use. I compensated by using an appropriately sized o-ring which helps keep the bayonette in compression. It would be better if there was something to keep the barrel from twisting (like a thumbscrew or even a latch)

First off the glue is absolutely amazing. I build custom cabinetry and furniture for a living and the strength of the glue is top notch but it sadly ends there. Every tube of glue will leak out about a 1/4 of its contents over the course of 10 minutes. That adds up to a lot of money over the course of your average kitchen. Also the gun is flawed. It locks against the trigger so if you’re holding the gun at an angle and squeeze the trigger it will quickly twist and fall apart. Luckily I hold on to the power cord while I use it and have saved it from falling onto the concrete floor every time. For the price of the glue this product should function 100 times better but the quality of the functioning aspect of the gun just isn’t there. If I hadn’t already used it on a set of cabinets I would be returning for a refund but I don’t feel that is right since I used it for a whole job.

The hot-melt polyurethane is indeed one of the strongest, most water-resistant glues I have ever used, so that's the main selling point. The gun itself isn't very well designed and tends to come apart during use. The workaround so far is to use a little tape to keep the two sections together, so it's functional.

I wanted the 30 second glue. I could only get the 60 second glue. Did a couple tests. After letting it sit for about 5 minutes (we were busy working), we were able to break the pieces apart. BUT, the glue didn't fail. The wood grain did. The glue held amazing. Well worth it. Now I'm going to buy some of the other glues.

Hard-core contractor reviewing the gun and glue! The glue is phenomenal! Takes a little getting used to but we love it. The glue gun is junk. Didn't make six joints before it failed completely. The power cord failed, had to hot wire around it to keep going. Made of cheap plastic and the barrel will not lock on and falls off at any moment. It will not hold up to everyday job site conditions. That being said we have bought a bunch of the adhesive, so I felt the need to buy a second one, because if it quits there's no substitute to keep on working. Called the company to visit about my issues and no response. Good luck with it!

no issues

Collé les cadrages en 45 degré et autre