AquaPro Liquid Patch Kit

We tore the bubble on our Intec above ground pool. We have had small holes in the past and had a hard time fixing them, but this tear was big and proved very difficult to patch. Every time we thought something worked air found it's way out and once the bubble loses air your pool can empty out quickly. This pool is 48" deep and 15' across and I cannot refill it once we lose the water. We tried Flex Seal Tape. Patched from the inside and outside. Looked good for a day and air found its way out. Found T Rex tape. Looked promising. Put some over the Flex Seal tape. Looked good, then it didn't. Kept putting more strips on and ended up with a giant mess of tape and air still leaking out. At the end of my rope I saw a couple of videos for this product. I reluctantly spend the $16 and change hoping for a miracle. I had to remove all of the residue from those stupid tapes, but the 3 hours it took to remove it with Goo Gone gave me a good base for the AquaPro liquid patch. I used almost the whole strip of mesh and the entire tube of patch. It looked a bit messy, but the instructions said don't mess around with the product once you apply it. It is self leveling from what I saw. I let it dry for 3 hours and then put a small amount of air in the bubble overnight. I didn't want to put too much pressure on the patch because I was looking to be disappointed. Guess what? It's been a week and it's holding strong. It worked! It's not pretty, it did make the bubble pucker a little, but I don't care. I have my pool and I am so happy!!!

The product is like a gel which is great because it doesn't run off your target repair easily. I struggled for a few weeks with trying differant patches from the manufacturer and third parties, and honestly didn't have much confidence, but this has held air in our inflatable hot tub for the third day straight with no loss of pressure. This worked really well and I have no complaints

This actually worked really well for repairing a hole in my inflatable boat and the patch has held up nicely. It’s much easier than some of the other repair methods I’ve tried. The only thing I would recommend is being careful with how much you apply. I used a little too much in one area and it seemed to soften and thin out some of the surrounding PVC material. As long as you apply it carefully and don’t overdo it, it works very well.

Great product for my leaking inflatable paddle board. It had a cut in it from scrapping against something and was slowly leaking. I tried other products that failed. This product worked first try with a drying time of 2 hours. Will recommend to others.

Worked great . Will see how it holds up over time. Was about ready to give up on patching til I found this product. Product is a little runny so surface needs to be as flat horizontal as possible

Easy to apply and blended in so that you couldn’t tell it was a patch. Blends in.

I used this an inflatable paddle board that holds 15 psi. Every pin hole patch failed within a couple weeks. A few months later when I’m looking to fix it again, the product just flakes right off the vinyl. It was clean and dry at time of patch, held for a week or 2.

It’s good but the tube of glue is too small for the price. I needed four times as much but 4 times $16 is ridiculous.

As advertised

I believe anyone who's having issues its user error i used this with the patch material that came with my stand up paddle board they almost all have 4 out of 4 inside the case with the wrench. Set up was very fast but I was ready with the repaire prepped. Its been inflated all summer without any signs that its going to have an issue. Would buy again for this and other uses.

Had a small leak in my paddle board. Glue seems to have worked! Haven't taken it out on the water yet though.

Had seam open on our paddleboard and this worked perfectly.

So far so good! Had a small home on a seem in our inflatable kayak where a patch wouldn’t work. This stuff seems to have held so far after a few months and pump ups! Actually pretty impressed