iJDMTOY Front Bumper Switchback LED Daytime Running Lights Compatible With 06-09 Nissan 350z LCI, Exact Fit Bumper Reflector Replacement Powered by White & Amber LED Lights

Excellent fit, looks great, not too difficult to install. Very bright and noticeable. Very happy and I recommend.

This product is top notch!! Comes with Water/moisture repellent electrical harness and junction boxes. Lens are perfect and overall quality is Excellent compared to other Generic similar products. What they picture on the listing is what you get!! I totally recommend!!

Perfect fit for my 07 350z. Plugs are well insulated and sealed from moisture. These add a great look to the already attractive Z. Truly a quality product, wiring is straightforward, light output is more than I expected. Very eased with this purchase. A quality install on mine took a couple hours start to finish. I pulled my front bumper and made sure all wiring was correctly secured but that's just my OCD and must have everything perfect

so far so good. working great and looks great.factory fit. very expensive.

I love these daytime running lights / blinkers.I installed them in the front of my 350z Nissan in about two and a half hours wired up and everything these lights are amazing change the whole look of my car I'm so happy with them. I'll be ordering the rear ones. Love them! Rick B.

Great lights but be careful works with OEM bumper and with some aftermarket not all bumpers that have the reflector slots will allow the lights to fit

Very good product recommend getting it :)

Really disappointed. I bought these lights to replace some other lights I had installed in the same location on my bumper. I received them today, pulled the enclosed directions and took them out to my car to lay it out for installation.I don't doubt that the lights are an exact fit but the supplied connecting wires are not.The directions, even though they are labeled "Installation Guide for 70-720", they are lights for a previous model car where the lights attach to the outside of the bumper rather than fit inside for the 2006 model. The picture in the directions clearly show a light with 7 individual led lights.Highlighted in the directions is the statement "Modifying the product in any way such as cutting wires or tabs, soldering, painting, etc voids the warranty". It also says to mount the module near the battery/fuse box to prevent water damage. The only problem with that is that their wiring configuration only allows you to mount the module a maximum 12 inches from one of the lights and then use the supplied extension to run to the other light. Without splicing in some wire and voiding my warranty, there is no way that I am going to be able to mount the module in the engine compartment to protect it.I went to their suggested website for "detailed installation" (not applicable). I called and talked to a tech. His final suggestion was to use two sided tape and stick the module to the back of my bumper. I don't see that as a very good option.They need to do two things. Write installation directions for the product they are selling and supply enough wire to be able to protect the module as they recommend.I am not sure yet which way I will go, void my warranty or protect my investment.After I install the lights, I will write another review related to how they actually work.