Creality Ender 3 Original 4010 Fans 40x40x10MM DC 24V Extruder Hot End Fan and DC 24V Turbo Fan for Ender 3/3 Pro 3D Printer

Fantastic quality

Bought this for my Ender 3 Pro Max as both fans stopped working, both worked perfectly now. Had to attached one of the fans with the original wiring which meant cutting it and connecting it to the end of the original wire (wasn't hard to do) but the other fan was a simple straight swap out.

Great for a like for like replacement but a very noisy fan!

After snapping the wire on my fan, I needed a replacement that would match my old one. This fan comes packaged in a brown envelope and has the wire tidily wrapped up. Both fans were in the same envelope but had a small tie to keep them from tangling. Unlike most replacements, these fans come with the correct wires so that they can be plugged in directly to the board (make sure you check which end is positive and negative before removing from the main board). My only issue with this is that the wires are about 2 inches longer than the original meaning they needed to be cut down to fit snugly and tidily. It is worth noting that these fans do not come with the screws needed and you will need to use the ones from the previous fan. The screws need to be quite tight to avoid the fan from making a loud vibrating noise. It almost seems like they need a slightly shorter screw. Overall, this is a good replacement fan that plugged quite easily into my Ender 3 Pro!

Item as described and works perfectly. Fitted in my Ender 5 pro. Cant give 5 stars on ease of install, but that is not to do with an issue with the product and more due to the nature of what you have to do to install it, which could be slightly difficult if you have no experience with electronic equipment.

Good value for money and very easy to fit. One fan needs to be attached to the main board by two screw and the other simply clips on to the board. No soldering needed, so no idea why some people are saying that you need to solder unless they are chopping the wires rather than threading the cables to the main board.

Extremely easy to install, took about 5 minutes in total. The difference is quite astonishing my original fan was noisy but this seems very quiet. The length of the wire was enough to reach the main board so no problems there. Good Purchase and reasonable price.

Works perfectly fine and arrived fast. It makes some noise, but I don’t really mind

Ottimo, pari all'originale montato sulla stampante

I have an Creality Ender 3 Original and the part cooling fan broke. Replaced it with this product and it's been working good

Buenos, es lo que esperaba

Ensamblaron bien en mi endre 3 v2, veremos cuanto duran.

I mean it worked so yeah