Thermo-Tec13500 12" X 12" Adhesive Backed Heat Barrier (4)

This worked great for my application! It was a little thinner than I expected, but that didn't matter too much to me.I applied it to the bottom side of a Creality CR-10 print bed. Fit perfectly with not cutting required. If anyone else is looking to do the same, be careful about the power leads on the print bed. Maybe even cover them with some kapton tape before applying this. The aluminized surface could easily short those babies out if you're not careful.Anyway, the adhesive is holding up fine so far even after being held at 60 degrees C for over 16 hours straight. I'll be sure to update this review if the adhesive starts to fail at any time.

I bought this not for use in my car, but in my freezer. My water dispensing tap in my fridge was freezing up and I saw that a product like this will help to insulate the plumbing from the cold. After I thawed out the nozzle using this great product https://www.amazon.com/dp/B01DJFFT62/ref=cm_cr_ryp_prd_ttl_sol_4 the problem has not returned. The self adhesive backing made it very easy to use in my freezer. It's cheaper than buying a new fridge.

Used to replace heat reflective backing on a Carbon Fiber heat shield for Moto-X bike. Able to cut sections to fit curves. Stuck just fine (did a very lite surface cleaning). So far, three days of riding, no problems.

Needed to put this above a toaster that was beneath and close to wooden cabinets. Before this heat shield things got mighty hot. Since applying this underneath my cabinet, no heats get through - none. Does what it's supposed to do and keeps the family safe.

Got some new plastics for my DRZ 400 and they didn't have heat-shielding material on the side piece that covers the exhaust. This was super simple to cut to shape and attach to the inside of the plastic piece. Five stars!

Patching my hood insulation after pack rat ate a hole on it to get at the insulation

I purchased this to try and solve a heat soak issue I had with my MINI. After wrapping the fuel pressure control solenoid with this stuff, the consistent problem I had virtually disappeared.I'd say it works pretty well at blocking heat. And it seemed to stick to the solenoid without problems.

Bought this to stop my refrigerators water dispenser from freezing. Wish it was thicker, but it worked. I did have to turn down the coldness of my refrigerator though.