LED Side Marker Light Ford F150 SVT Raptor Pick Up 2010-2014

I ended up picking these marker lights up after one of the lights went out. I originally planned on replacing it with the factory ford part, but after looking on the other side, it was pretty worn out looking too, so I decided to save a buck and order these. The removal and installation is easy enough. You can get it from under the truck no problem; however if you are having problems or its not easy for you to get below the truck for whatever reason you can pull the three (3) 10mm bolts on the either headlight to give you extra room. 2 of the bolts are on top and face upwards, one is about halfway down on the grill side of the light. Easy peasy, just unbolt and you can get at it no problem. Another thing that some of the reviews state is that is that you need to completely cut the rubber grommet between the body and the light itself, or cut the wire and splice it together to make it fit. Thats not the case at all. When you remove the grommet from the body make 4 small cross cuts on it and it will allow you to thread the plug through it while the grommet will still retain its structural integrity and keep the light in place once you install it. Just be careful and do it slowly. I used a hobby style exacto knife, but a sharp pair of scissors will do the trick. Once you get the grommet on you can thread the wire through the mount and plug it in. Super easy job, even if you need to take the headlight off to get at it. Once installed the light is just as bright as stock when on, and more subdued when off. If you liked the smoked look, it will do the trick.

Good lights for the price, the other reviews are correct in terms of the light appear to be more of a ‘bar’ than individual LED lights but they work and are cost effective nevertheless.

Much brighter than stock. Direct fit and replacement only thing needed is to cut the rubber grommet to fit the connector end. Wish the wires came with wire loom like the factory lights do but that's easy to add if you want.

Reuse the rubber base, look great

They weren't plug and play. I had to splice them but I half expected that. They work great though. Very happy with them.

Worked flawlessly, looks good and they are pretty bright.

1 died within 60 days. You have to take it apart to get into the hole in the cover

Look great! The only piece you have to modify is the rubber grommet. Everything is plug and play.

merci

Wasted time buying these. Does not come with rubber grommet required to replace and seal the light from water/moisture. There's no way I'm cutting into my existing one to try and makeshift a solution that won't for sure work. Buyer needs to specify this clearly in the description.