BalanceFrom Bike Trainer Stand Steel Bicycle Exercise Magnetic Stand with Front Wheel Riser

I was somewhat reluctant to purchase this based on some of the product reviews, but I rolled the dice and was NOT disappointed! Let me refute some claims in other reviews: (A) It is VERY easy to assemble. There is ONE bolt to install the resistance wheel to the trainer frame. The instructions are pictorial only, but every screw, washer, bolt, and tool (included) are labelled. If you can follow "align bolt A with washer B into hole C and tighten with bolt D", you'll be fine. Its not rocket science. After attaching the resistance wheel to the trainer frame, be sure to align the tightening screw (with the big nob) into the bolt on the resistance wheel. Again, its not rocket science. (B) Attaching your bike to the trainer frame might be a little awkward the first time, especially if you are doing it by yourself, but its not difficult. After you get it right, removing the bike and reattaching it is easy. With some bikes, you may have to replace the axle pin (included), but I did not have to do that. My 25 year old mountain bike attached fine the first time. RECOMMENDATION: Do not rush this step or you may find your bike slipping out of the trainer frame and you flying across room on your moving bike!. (C) A front wheel stabilizer IS included. Once my bike (with 26" mountain bike tires) was attached in the trainer frame, the front wheel sat 3" above the ground and the real wheel sat about 2" above the ground. I am using this in my basement with 7' ceilings and still have headroom when I ride. (D) Noise. Its not silent, but I would not describe it as "noisy" either. I would compare the noise to that of a someone using a vacuum cleaner on the floor above you. Its more of a "drone" or a "whir". Pitch varies with speed and - for me - at a low-moderate speed the noise definitely gets more pronounced, but is less so at low, moderate, and higher speeds. My trainer sits on a "commercial" type carpet that you'd find in an office building. To say one needs "noise-cancelling headphones to watch TV while riding" seems way out of whack with what I am experiencing. (E) An adjustment dial can be attached to your handlebars, nut it does not do much (I'll agree with that!) but - once I set the base resistance using the nob at the back of the resistance wheel (while I am off the bike), I am able to use my front and rear derailleurs to adjust resistance somewhat (its not as pronounced as when you are riding on the road, though). You can then use adjustment dial to make small resistance adjustments within a gear (if that makes any sense). NOTE: I used 2 or 3 small Velcro straps to attach the adjustment cable to the frame. This is not necessary if you plan on using your bike in- and out-doors, or moving the bike between uses...but I plan on keeping it where it is until spring/summer, so the Velcro just keeps things tight and tidy. (F) The workout: Call me Captain Obvious, but the higher the resistance you set initially will determine how hard you work. I'm still playing with it to find the right setting. What feels "right" at first may be too tough to sustain. My first workout kicked my butt. You will likely find yourself making many small adjustments at first until you find your "sweet spot" BOTTOM LINE: Looking for a budget bike trainer, this is the one. There is nothing out there less expensive than this. Its sturdy AND it does the job. Are there better, quieter, more feature-rich units out there? Sure...but a 2 or 3 times the cost, or more! If you are looking to buy an inexpensive indoor bike trainer to help lose your COVID-15, this is definitely worth the investment, IMHO

First, as stated in the description, it can get a little noisy if using high thread tires. It kind of sounds like a kid's wind up toy or siren. I found it to be tolerable, but it's something to consider if living at apt, or if intended use is at night. The entire unit was fairly easy to setup once I got past the quick-release issues (more on that below) and it's quite easy and quick to put away and set up again. The base unit feels very sturdy and the adjustment knows give you good control over the resistance provided to the tire. The only issue was that I initially tried to follow the instructions to install the quick release adapter, but what the instructions didn't say was that they are assuming you already have a quick release wheel (Note: at the time there was no mention of this issue in the product description either). If you don't, you need to purchase an axel to turn it into one. In the end, I had to put everything back together again and tried to just mount the bike using the existing wheel bolts, which fit perfectly. The whole thing was unnecessary, at least for my bike. Seeing that the description now mentions briefly the difference between quick release and bolt structures, they might have made changes to their installation instructions as well. Overall, I'm satisfied with the purchase and would recommend the item.

I bought this for my sister as a Christmas present to train for the PAN mass challenge in Massachusetts. It was so easy to set up and when you want to use your bike, it’s easy to remove it to take your bike outside and use it outdoors. Prior to purchasing this item I read the reviews. A few people stated that it was noisy. My sister and I don’t find it noisy at all. You can hear the tires & the machine turning however you can still have the TV or music on & hear just fine without having it up too loud. It’s light and easy to pick up and move anywhere you want in your home. I would recommend this product to anybody.

I bought this trainer 2 weeks ago, replacing a trainer I'd had 5 years ago. I have to say I didn't think it possible to buy a mag trainer for less than $100 that would be good at all. I was shocked and skeptical at tis price point, but the other reviews made it worth a try, and $35 is hardly a lot to risk. The trainer came in 3 pieces -- assembled frame, mag unit with resistance shifter, and thru axle. It was well packed but wish the mfgr would ship with cardboard stuffing instead of styrofoam (time to rid the world of this stuff). The rack was assembled and required only bolting on the mag unit, with a single bolt that was present in the mount and needed only be pulled out, inserted through the mag unit, then firmly bolted on. I have a Specialized brand bike that did require swapping thru axles with the one provided, a 2 minute job, as my bike's thru axle did not fit well in the two axle mounts. Once done, the bike mounted easily in the axle mount. The axle mount retractors were easily adjusted, but there is a lock nut that needs to be slid outboard to rotate the mount screws (actually, nice, simple design). In use, I find that with modest pressure against the tire (adjustable with a screw on the mag unit, after assembly to the frame) I can ride with the resistance setting at 2 or 3, and my bike in 3+3 on the shifters. I get a good 35 minute workout at 136 BPM heart rate. The mag unit is not unusually noisy - the noise is mainly tire friction on the roller, not the mag unit internally. It is what one would expect, depending on tire type -- mine being a road tire with not much tread. More aggressive treads will be louder as they produce more noise on the roller. I am able to ride with a small bluetooth speaker at modest volume without the mag unit making noise above it. The frame is sufficiently wide that I am stable laterally while riding, but does close easily when moving it (watch fingers!), but totally stable in riding position. A cross bar once the frame is open, to keep it so, might be a nice addition in a future model. Overall, very happy with this unit, it is every bit as good as my previous trainer that cost 4 or 5X this one. Hard to believe this level of quality for $35. I would recommend to anyone.

I bought one like this years ago and used it every winter then moved and now just replaced it. I already had a quick release axle so i could just tighten it right away. I'll get a street tire added later. noise isnt too bad since i have a rougher tread on it. the tension is great and you can even change your gears. great price. easy assembly. gives good tension for work out. strong and good quality. wheel is secure. need a stool to get on and off. its high. i recommend it.

Does the job — turns your regular bike into an indoor setup, holds steady, and the magnetic resistance gives you enough to actually work with. The included front wheel riser is a nice touch. Not silent, not fancy, but at this price it’s hard to argue with. Pros: • Great value • Magnetic resistance with multiple levels • Front wheel riser included • Folds up for storage • Easy to set up Cons: • Louder than higher-end trainers • Resistance feels less smooth than premium options • No connectivity (not a smart trainer) Tips: • Use a trainer-specific tire if you’ll be on it a lot — regular tires wear fast and shed rubber • Put a mat underneath to catch sweat and dampen sound • Tighten the resistance roller against the tire properly, otherwise you’ll get slippage • Your local bike shop is a great resource if you want to upgrade later or get fitted properly Four stars. Great entry point for indoor riding.

Excellent purchase during snowy winter months of Michigan, when my bike is sitting at a corner and collecting dust. Took 5 days to deliver, which isn't bad considering we are living through a pandemic right now. I am a DIY person who has put together many pieces of IKEA furniture and other items with good instructions and tools. All the appropriate tools come with this assembly, but the instructions were pictures only with no written narrative. Overwhelming at first, but then with a little extra resolution, and after laying out all the pieces and studying the photos in greater depth, it only took about 15 minutes to actually get it all together! It is super sturdy. Very pleased and excited to be able to exercise and put my bike to work, instead of sitting idle. The only downside is the noise (giving 4/5 stars rating because of that). Since I own a mountain bike with fat tires (as you can see in the pics), the noise level is similar to someone drilling into the wall! My cardio routine usually lasts 30-45 mins, so planning to replace my rear tire with a trainer tire, before my roommate kicks me out or my downstairs neighbor starts complaining. Tip: Make sure that the bolt that pushes the roller against the wheel is seated correctly on the roller, then you can tighten it until you can see pressure on the tire.

I checked out many bike trainers on Amazon. I watched the video's here and on YouTube to get as much information as I could in order to choose the right one. Prices ranged from $45 to $100+. I settled on this BalanceForm bike trainer because it had the front tire stand and the axel. The price was great, because the cheaper bike trainers ($40+-) didn't have the stand, which adds $6-8 to the price. I ordered this one and after reviewing the set up videos again, I had it set up in no time at all. No issues other than a missing bolt to hold the tension changer on the handlebars. Found one that fits from my own stash of bolts in my garage. Noise level is not bad, my dogs were concerned at first, but after a while, it didn't bother them. I saw a video on YouTube on how to get the trainers to be more quite. First, is to get a trainer tire that has no tread and to make sure everything is oiled. I don't think it is necessary as I still plan on using my bike on the road and don't want to make things MORE difficult and expensive to use the trainer. I decided NOT to use the tension controller and just laid it next to my bike. For me, the tension is fine and I can change gears to make it more difficult, should I choose. Overall, I am very happy with this bike trainer, I would 100% recommend it because it was easy to set up/take down (I use it in my living room and store it in my garage) and it does exactly what I want. Another tip is to get a good fan and use it to stay cool. My goal was to stay out of the South Florida Sun and be able to hang out with my dogs (separation anxiety, me, not them!) Win/Win.

Rápido y fácil armado. Muy buena estabilidad. Mucha eficiencia y eficacia. Excelente relación precio-utilidad. Muy buena apariencia. Lo recomiendo ampliamente.

Cumple perfectamente con lo deseado.

When you put the bike on the trainer and start your workout the bike in moving

I couldn’t be happier with the BalanceFrom Bike Trainer Stand! It’s an absolute game-changer for indoor cycling. The stand is sturdy, made of high-quality steel, and feels incredibly stable even during intense workouts. The magnetic resistance works smoothly and provides a range of levels to customize my training. The included front wheel riser block is a great addition, ensuring proper balance and comfort throughout the ride. Assembly was straightforward, and the foldable design makes it easy to store when not in use. Plus, it’s relatively quiet, so I can use it without disturbing anyone in the house. This trainer stand has allowed me to keep up with my cycling routine, rain or shine, without the hassle of going to the gym. For the price, the value is unbeatable. I highly recommend it to anyone looking to stay active indoors!

I bought this Bike Trainer when it was on sale to use indoors with my first road bike I bought last year. First time I’ve ever used a Bike Trainer, but so far I’ve been quite impressed! Set up: fairly straightforward to set up. No English instructions, but the diagram was helpful and came with the needed tools. I did have to google how to replace my rear wheel bike skewer with the one included, but if you have a quick release tire, it’s actually quite easy. Lots of tutorials on YouTube. Usability: the design is intuitive so it’s easy to understand how everything works. It comes with a dial to clip onto your handlebar to increase or decrease up to 8 resistances for your rear tire. I’ve noticed it tends to get a bit noisy the further you tighten the roller into the rear tire, but I’ve be been leaving it a bit loose and it seems to work fine without much noise. Overall value: good product, sturdy, foldable when not in use, comes with a separate front piece to rest your front wheel on (usually sold separately). When on sale, it’s one of the cheapest options out there. So far very satisfied.