Rotary Cutter Blade Pan (Stump-Jumper) for 40hp Box

works as it should

Waste of money, the blades just get hung up on each other and don't cut anything

Hole not lined up had to grind to get bolt to go through. After that everything was good.

Fit like a charm. As much as anything can fit a 20 year old piece of equipment smoothly.

After much searching, found this pan. Lot of work to replace but the pan itself is of good quality and have been holding up well.

Very easy to decide on this item. All the proper measurements were made in the purchase description and the price was the cheapest I found.

I needed a replacement gearbox, but the new ones would not fit my blade bar... so I had to buy the stump jumper too $$ . It is very good quality, heavy duty, but for some reason the center nut is indented only a half inch or so and most of the nut is exposed to rocks, or in my case to my old blades that swing into the nut when I hit a stump. My old blades do not have a quick enough offset to clear the nut. So now I suppose I will have to go buy new blades. $$+$$ I say the stump jumper should be indented and the nut protected.