🔥 Don't Let the Cold Slow You Down!
The Zerostart 3600006 Replacement Cordset is a 5-foot, 120 Volt cord designed for efficient heating of freeze plugs, engine blocks, oil pans, and transmissions. Featuring a durable silicone connector and a right angle design, this cordset ensures reliable performance in cold weather conditions.
K**S
Shorter than stock cord.
The plug is a 90 degree end not straight like the original and the cord is a foot shorter so had to take a different route. Also would be nice if it came with the heat shield like the original. All in all it works. Need to research and find a heavy duty cord that is round not flat. Good luck.
H**E
Works great
Thanks works great
G**M
Works perfect!
Bought this to replace the one on our truck. It works perfect and was easy to install.
C**A
Cord not rated for *very* cold temps
I had to replace the original cord, as the insulation cracked in several places due to flexing the cord in very cold (0 to -10F) conditions. You would hope the materials used would be rated for this. Also, the replacement cord no longer has a thermal sensor that shuts off when it's above a certain temp. Without the thermal sensor, I can't justify the cost.
C**E
2011 LML block heater
This worked great for my 2011 LML Duramax factory block heater.
T**N
Fits 80's ford but, very difficult to get the plug seated
This work for a Ford but, the Right angle of the connector makes it very difficult to get seated into the block warmer. Takes at least 3-4 minutes of fiddling before I can get the plug fully into the outlet. It works but, if I had to purchase again, I'd find a plug with a straight connector.
K**.
No 90 on the OEM
Quick shipping, it’s not an exact fit for my 2001 Duramax. I was able to use it but the original oem does not have a 90 so it is a bit of a pain to make it fit..
J**T
Good buy for the price
Good fitment, a little short in length.
F**E
Thick insulation but very hard to install
The three prong female connector is very hard to install it's too thick and requires a ton of force to get hooked up
C**R
Heater cord
Fit perfect
M**W
What it is
It did the job and nicer than just replacing the plug part. Very happy
S**R
Great price, works great and fit perfectly
Bought this for a used 1997 Ford Explorer we bought for our daughter. It was cheap, works perfect and fit perfectly, installed in 5 minutes. Definitely a good purchase.
A**R
Well that was easy
I really appreciate the checklist amazon does to make sure the part fits for the car. I needed a YouTube video or two to figure out where it needed to go and the position of the plug, but it went in super slick when I found it. Saved my car from dying in the Canadian deep freeze. Only request would be to add a plus cover please. There's nothing protecting the plug from the elements and my previous is too small
Trustpilot
3 weeks ago
1 month ago