Mud Flaps Kit for Jeep Compass 2017-2024 Mud Splash Guard Front and Rear 4-PC Set by TOPGRIL

Fit good, slight trimming needed for right rear

All but right side rear where easy to install and i used my original hardware. You will need to cut a little. It if the plastic off on the right side for it to fit flush. It does not take away from the appearance from the outside. The keep is not flat on the back but the mud guard is. I took a picture to show you. Just used a razor blade to cut it off. Very simple. Took 20 min to install all four guards. Would recommend.

These were listed as fitting 2017- 2024 Jeep Compass models. I installed them on my wife's (new to her) 2019 Compass today. Had to do some significant retrofitting to get them attached. Only ONE of the two or three (depending on if front/back mudflap) holes pre-drilled in the flaps matched the existing fastener holes on the vehicle. The other two were at least 1/2" away from the existing fasteners, and no manipulation could get the holes in the flaps to line up with the factory fastener holes. Also, the instructions say to remove the existing screws, but on the 2019 Latitude version, there is only one removable screw, and the other fasteners are those plastic Fir Tree fasteners. If you remove them, the holes (IF they'd lined up) were far too large in diameter for the screws provided to hold the mud flaps in place. I wound up drilling new holes for the screws provided, and leaving the Fir Tree fasteners in place UNDER the flaps. Also, the original screw-out fasteners (threaded U-nuts/screw) were not the same thread as the screws provided, so on the single place on each I COULD use one of the originally positioned holes, I simply re-used the factory U-nut/screws. On the plus side, the mud flaps do perfectly match the contour of the Jeep's body, so once I retrofitted the attachment of them, they look fine.

Perfecto me encanto

I started installing these on the drivers side and they fit well. I then went to the passenger side. When I got the the rear, it did not fit. I had to cut a couple inches of the plastic off to make this fit into place.For $40, you'd think this would fit the vehicle without having to modify it!

These are very nice, and fit perfectly for the most part. The only one I had a little trouble with was the right rear one, due to the shape of the splash guard on the bottom. These flaps come with hardware, but it wasn't needed on my installation. On the front two, you remove two body clips using a knife or flat screwdriver blade (or a clip removal tool), and an 8mm bolt on the bottom. Then replace them going through the holes in the flaps and into the body. The rear ones have two 8mm bolts. (Note: The bottom tab hole on the flap isn't used on mine). Now, here is where I had a little trouble lining up the right rear flap going back on. So, I started the top hole first and mostly tightened it, and was able to catch the bottom hole after that. Tighten carefully and don't overtighten. You're done!

they are to narrow to defect the wash thrown up by the tire so they do not help!

First off I will start of by giving the product 5 stars. The description say it is not for the Jeep Compass Trailhawk specially for a 2021 model (not listed) but that did not prevent me from purchasing the product. It will work with a minor modification to the passenger side rear flaps if you dont want to spend $100+ for OEM/Mopar. You will just need to cut/trim off a small portion of the splash guard to have it sit flush to the wheel well. After that the other three splash guards went on with no problem. Color wise it is a little lighter than the rest of the black trim on my Compass. We will see how long it'll start fading in the Arizona heat. All in all I am satisfied with the fitment and quality for the amount I paid.