Will fletch 3 fletch 120 degree,4 fletch 75X150 degree,60X120 degree and 90X90 degree, cock fletch up, down out or any angle desired. Head is degreed using a CNC milling which is accurate to one ten thousandth of an inch, for setting both the fletch and nock angles. Indexable upper shafts support is designed to hold each size shafts from 12/64 to 27/64. Hardened indexing contact points for non-wearing accuracy. No ball bearings. .
D**A
Good design, needs some help to make it worthwhile
The features and design of this jig are great, tons of options for fletching your arrows.The quality of the right helical clamp I received was abominable, it just didn't work because the edge was so poorly shaped.FORTUNATELY! the Bitzenburger right helical clamp fits great on this jig.The edge of the straight clamp wasn't good either, but it works ok because it isn't holding anything at a contorted angle.
R**R
Cheap junk
This jig will work, but not very well. It's poorly made plastic with only the absolute minimum structural integrity and precision. My biggest complaint is the plastic clip: its jaws are not straight (I didn't buy the helical). They're very wobbly and it caused a noticeable deflection in the forward end of the vane. It was correctable with some light sanding of the jaw, but I would recommend a different product. Unfortunately this is the only one I've tried so I cannot say what the competition offers.
M**M
Manageable errors
This is one of the most versatile all-around fletchers I’ve used. The nock angle indicator has a 25 degree error built into it (the plastic is cast out of alignment) which can be easily accounted for. After a little bit of tinkering, it works great! After it’s all dialed in, it’s solid.
A**A
Great lower cost alternative
Great lower cost alternative to the Blitz. Downfall as you would expect is that after clearing/sanding hardened glue of 500+ arrows you may find yourself wanting a new clamp. But replacements are inexpensive!
0**E
Best fletcher out there.
I've used this for years. I have no complaints. I prefer it over the arizona ez fletcher.
C**O
Works as should
This thing is doing it's as it should. I'm 3 fetching blazers. It can also 4 or 5 fletch. As others have stated the glue does stick easily to the plastic but that is what tape and sandpaper is for.
C**E
Five Stars
Easy to use, can set 2 degree right off set that Ten Point recommends.
R**Z
A good buy
A good jig. I did have to fill a slight bow in the mid area of the clamp with some tape, but that took care of it. I would recommend this jig.
Trustpilot
3 days ago
1 week ago
