Heater Blower Motor Fan Resistor for Fiat Grande Punto Qubo 13248240 77364061 55702407 6845796

Perfect replacement for the older rusty one. Even made all the fans work again so super happy. Also made heating come on quicker

I have bought it again, since my brother has a similar car, I recommend it

Heater fan on the Punto kept losing speeds until only one was left number 4, this resistor replacement fits perfectly and restored all the speeds and comes with the extra loom piece as the connector's tend to burn over time. On the Punto it's not the easiest to get to and is awkward to replace but saves on garage fee's if you can do it yourself.

It works fine however, the wires didn't match colour for colour, just use a chocolate block to connect it then you can test settings 1,2,3,4 on your blower, if some wires need swapping then it becomes easy to do rather than use crimp connectors..

This turbo motor shattered once it was installed it has cost me further money to fix

Ordered this based on a previous review of a 2008 Punto saying all OK, but after swapping the wiring over and proving the fan worked on all speeds I tried to fit it back in the housing and it would not look back in, seems the 4 locating lugs are of different dimensions to the original 3 I have that slide home fine.

Brilliant, worked at treat on a 2008 Punto Grande. Sniped off the old burnt out electrical block, re stripped the cables, got a set of crimpers and some connectors. There's 5 cables, used yellow connectors on the 2 larger cables and blue on the smaller cables. Everything crimped up in 10 minutes, removed old resistor from housing and replaced with new, be careful to make sure the new resistor is seated correctly. Put some electrical tape over my new joints, plugged back into the resistor - ignition on ! Fans working great !

I bought this item and installed it in my car to replace the previous part that had eventually failed. My suspicions were initially aroused when the two parts didn't clip together properly, the locking piece failing to engage due to them not fitting right. The green paste covering the electronic section also arrived pre-cracked, with a spiderweb pattern of fault lines across it. Within a week the connection between the two parts of this kit had melted - presumably cheap plastic and a crappy connection - and my heater no longer worked.Not worth buying. Poorly made imitation parts, waste of money.