exactafit 8722L Driver Side Mirror Glass Replacement Repair Compatible With 1985-2005 Chevy Astro, GMC Safari

Seriously, this mirror fit perfectly! It came with 3M double sided sticky circles, I had it in place in seconds. Very happy with this product.

Worked great, fit perfectly, easy to do.

Completely worth it. Cheap and affordable.Only con I can tell is that the image is slightly.....SLIGHTLY distorted. But you'll get used to it.Would buy again if I had to.Shipping was 1 day. Broke it last night. New one on by 1pm next dayCame with 6-2in 3M double sided sticky circles.

So this thing, it's supposed to fit where your previously broken side mirror was. Well the shape was close, but it wasn't quite right. But, there's a little plastic edge surrounding the mirror, so if the fit isn't quite right, it doesn't really work. So I had to take a sharp chisel (I'm a woodworker so I have about a dozen chisels sharp enough to shave with) and cut off the plastic edge that sticks out along the bottom edge of the mirror in order to get it to sit flat, which it would need for adhesion. But, it works and looks good and is a huge improvement, it just had to be messed with a little bit. That being said, the mirror I replaced had been on a whole side mirror that had been replaced previously, so that might explain the improper fit. However, the mirror on the opposite side is presumably original and the replacement mirror didn't line up with that one either. Also, you're supposed to chip out the old broken mirror glass, which is a bit of a messy chore and dangerous because little shards of glass go flying everywhere and it's probably a good idea to wear eye protection. But, it worked.

Easy to install and months later and on Puerto Rico's roads, it's still there.

The mirror didn't fit, but with quite a bit of effort, was able to grind it down on a stationary belt sander to be useable.

Took me longer to remove it from the packaging that to replace the old mirror. Perfect fit and plenty of adhesion. I'm happy with it.

Exactfit is the name only and it was not an exact fit. Because this is and old car I didn't have a lot of choice to replace the broken mirror. I ended up using a dremel tool to adjust the fit of the mount. That took about 30 minutes of grinding a little here and there and trial fitting it. Because of the mount being bowed, I opted to fogo using the included two sided tape strips and used a good quality RTV as the adhesive. Once complete and cleaned up it looks as good as an OE mirror. If this breaks I would purchase again.