Pre Wired Dominator Industries 1 1/4 Inch Road Glide Meathook Ape Hanger Handlebars, 14 Inch Rise, Gloss Black for 2015-2022 Harley Road Glides

Order arrived early and easy to in stall. Quality product, comfortable and a great look to your bike.

I was a bit worry after reading some of the reviews and looking up the company BUT product got delivered fast and it was easy to install. No complain here

These bars look like they had a rat gnaw the port in them. there are razor sharp sharktooth burrs in the opening, as well as burrs in the meathook bend that were snagging and cutting my wire.After pulling my heated grip wires through and seeing all the cuts in the wires, I did not feel safe plugging the grips into my brand new $56000 2022 CVO road glide with 30 miles on it. There is zero excuse for bars to be sent out with issues like this. there was weld splatter coming out while I was pulling the wire as well. These meathooks are hard enough to fish wire through when they are smooth, add sharp edges and its a nightmare. I contacted the seller directly asking for them to work with me on the $300 heated Kahuna grips their bars destroyed and they told me I had to go through amazon even though the product is sold and shipped from Dominator Cycles.the only option amazon has is to pull them off and try to pull out my twist grip sensor without breaking that on their burrs, and send the bars back, which leaves me with no bars and non functioning heated grips and a possibly destroyed twist grip sensor. not to mention all the wasted labor time installing and removing these bars.This company clearly does not stand behind their product whatsoever. I highly recommend buying Factory 47 bars, as they have much better quality control. I will never buy another product from Dominator Cycles again

These handle bars are great. Nice workmanship easy to install. Dominator thought of everything you need, except tools, to do it right and fast. The hardest part was pulling the shrink wrap over the throttle wires. Watch the videos and read through the instructions for all the tricks to make it a smooth install. The whole job took me a little over 3 hours and I was taking my time to do it right the first time.

They were a pain yo pull the wires through. Took a solid hour and had to use chain instead of what comes with them. They look great once on and are a comfortable ride. Seem sturdy as far as biuld

I left these bars wrapped while installing. The packaging was great. Still Had a nick right on the corner from OEM. The heated grips wiring on stock grip is glued in so I still had to run that. Still need extension for clutch. Front brake is pulling the line a bit to much for my liking. REMEMBER TO PULL THE MAIN FUSE BEFORE INSTALLING.

I was very intimidated in doing handlebars, I’ve only ridden cruisers for a month. I had to reroute the brake and clutch cables and knock down the pin at the base of the handlebars. The review that shows they were offset is 100% accurate. Tap down the pin and you can adjust them to the left a bit. I struggled getting the wires ran, then I tapped a hole in the bottom and the throttle cable pulled through fine. Took about 5 hrs total, and I’ve never worked on a Harley or a cruiser.

These bars are awesome. We took the extra time to wrap our throttle cable well and super tight with electrical tape... took us a total of about 5 minutes to slowly and carefully work it through the bars. It does not pull through with ease but prepping well made it not bad at all.