12V Wireless RF Remote Control Relay Switch Universal 2-Channel 315MHz Receiver with 1 Transmitters for Garage Door Openers, Cars, LED Lights & More

Using it to reboot 4 off grid inverters from roughly 300 feet away. Works better than planned.

The media could not be loaded.  The remote does not come with batteries and requires a 23A 12V battery.Reset module by pressing and holding white button for ~8 seconds.To program both channels: press the white button on the module, release, immediately on the remote press “A”, release, indicator light will appear and then immediately press “B”.The module comes preset with momentary mode enabled; this can be changed with the jumper (1 2 3) next to the white button.

Got everything wired up and programmed last night. Seemed like it worked perfectly for my enclosure lights until about 5 minutes later. For reasons beyond my understanding, the relay would randomly start toggling on and off between the different relays without any buttons being pressed on the remote. Do i need to recheck the wiring, or call a priest?

Applied 12v of power and was trying to program a remote I had when a capacitor exploded on the circuit board and went flying into the air.

Simple, easy to set up and use remote control.

Work great

Real rookie when it comes to electronics. Not sure if the unit is not functioning properly or if it is a wiring problem on my part. More detailed instructions on how to wire a dc motor (for example) would be helpful.

Nice!

Control remoto de muy buena calidad