HiLetgo 2pcs Water Pump 240L/H DC 12V 4.2W Micro Brushless Pump 3M Pumping Head Ultra Quiet Water Pump for Pool Aquarium Fish Tank

Very good functionality, pumps and flows well, durible, easy install. Use a filter to keep debris out of impeller.

Not a typical application. Sailboat life hack. My 2 foot pumps quit. $300 to get 2 new ones shipped to Fiji. Or $13+ for two of these, plus shipping. Not a lot of free shipping to Fiji.These 2 pumps and 2 momentarily “toe buttons” (where foot levers use to be), made life flow again. If these things age good enough for salt water aquariums, they will do what I need. Tiny plastic check valves will refine their operation and I expect they will long outlive the foot pumps I would have bought.The wires and only tinned on the tiny bit that the manufacturer stripped back. Not enough exposed to make a connection. If corrosion is a concern and you want to get max life out of them, strip back more wire and tin enough to do the job.This is a low dollar resolve that I expect to be happy with for a long time.

I needed it to pump at least a trickle up tp 6 feet. It could not even pump 2 feet. Not even a tricle, either of the 2 pumps. GARBAGE !!

I’ve purchased many of these small fountain pumps. I use them water potted plants with a timer, battery, solar panel setup. But they don’t last long. Maybe 2 to 3 years outside.

These are great for the price point.When they are working they move the expected amount of water. Pressure is proportionally weak, but that is a side effect of spending the available energy budget on flow/volume/mass. You would need to move less volume to get a higher pressure for the same watts, that's just physics. With a hose the same ID as the barb, I get about 2-4 feet of lift before back pressure causes it to stall, which is damn good for the flow rate and the sub 20 Watts honestly.The biggest con is they are bad about cavitation and priming. You have to be very particular about keeping the input loaded with only water. Even as small as a few CC's of air will cause stall/cavitation. The problem can be worked around easily if you have a level head on your shoulders.Basically, these are ideal for relatively high flow and reasonably closed loop applications. Liquid cooling PC's, fish/fountain pumps, etc. Not as great for situations where the input is getting exposed to air, or expected to start from an air locked state. Definitely not good for anything that relies on pressure to get the job done, e.g moving fluid against gravity, spray washing systems, etc.Haven't used them for anything other than fresh water, so I don't know what other liquids they could handle.

You get what you pay for, theae are cheap in cost and ability. But if you treat them correctly they will workBut don't let any debris get in, the pump will seize up and you need to remove the tiny 4 screws and remove the debris.However, because of the design, clogging the pump and causing it to seize will not hurt the pump.The pump.needs to in the chamber to work. One little air bubble and the impeller will spin ans not pump liquid.

Fittings are easy to connect to a hose. Everything we needed was in this set. We bought this for a greenhouse irrigation system and have found it to be durable and reliable.

Works as expected used as a pump on a custom water cooling setup on a PC.