Standard Motor ProductsS682 Pigtail/Socket, 1 Count (Pack of 1)

The sockets arrived quickly and just as advertised. The sockets are a perfect replacement for my old brittle and busted original headlight plugs on my Ford Excursion. The pigtails gave plenty of slack in order to properly tie the new plugs in. I highly recommend this part, and this seller.

it was for a 1999 f150 and not sure if it was already bent up or just got bent while I put it on but the middle prong got twisted sideways and never connected and couldn't get it to work, ok I just tried it again and pulled the center wire out and repositioned it and got it to connect. just gotta be careful connecting it to the socket, twist pretty easy

I ordered 2 of these connectors. One came in with a pin receiver turned 90 degrees inside the connector, meaning it could not match with the mating socket. Luckily I have the terminal tools to fix this. But both connectors came in missing the retaining clip inside that orients the pins and keeps them from pulling out. I had to reuse these clips from the original connectors I was replacing.

Worked perfectly on 2003 f150 headlight assembly...wire colors matched perfectly also

Great item, great price.

Exact Fit for many Ford, Mercury, and Lincoln vehicles from 1990 through 2006 - check before ordering. Fits Front: Parking Lights, Turn Signals. Fits Rear: Parking Lights, Brake Lights, Turn Signals. Comes complete with Rubber Gasket that seals against the socket (as pictured). 3 female terminals inside correspond to the 3 wires *Power (green); Neutral (brown); and Ground (black) Each wire from pigtail is Seven (7) inches long. The S682 Pigtail easily snaps into the Dorman 84765 Turn Signal Lamp Socket (sold separately at Amazon) for a positive,leak-proof seal. The perfect combination for installing an upgrade to LED bulbs -- for a brighter, safer, modern-looking vehicle. My order arrived promptly and in perfect condition.

Repaired a defective turn signal on my "97 Wrangler with this pigtail and a Dorman 84765 Turn Signal Lamp Socket. I recommend using heat shrink solder connectors to make the connections water resistant. $25 worth of parts and 20 minutes time fixed an issue that's plagued my Jeep for years.

Exactly what I needed worked like a charm.