BridgeMount® Low Profile Picatinny Angled Mount, 2.16" Long with 5 Slots, BM05D45

Vary well made, good quality hardware. I bought this for a offset flashlight mount, but ended up using it for a red dot offset on my AR10. It fit under my vortex scope where a rear iron sight would normally fit. The angle is perfect for a offset red dot without having to move your head to find the dot after rotating the rifle from the magnified optic. I have ran around 300 rounds with it on and I have had no shift in zero on the red dot (Bushnell tsr-25)

very good works perfect will be used thanks

Exactly what I needed. Used it to mount a reflex sight at 45 degrees on a .45 ACP carbine so I can co-witness along with a scope mounted on the top rail. The low profile puts it in a much better position than the standard profile, which puts it too high and too far to the left to view comfortably when shouldering the weapon.

Nice mount for the money. Fits great, tight, straight, & sturdy but the screw top to add a top rail are a little weak. Be careful don’t over tighten the top rail. You won’t want to change the top rail once you get it on there.

Exact fit and spacing to get my MBUS sights in an operable position. My Nikon mounts and Scope needed more offset to clear the mbus for clearance.

These are NOT 45 degree mounts. If they were, then two of them together would create a 90 degree extension. They are more like 35 - 40 degree mounts. Two of them are short of 90 degrees, and 3 of them are more than 90 degrees.

Didn’t end up using it but I’m sure I will eventually

Very good 45 mount but the side holes are not drilled level so the option of bolting the side rail on is worthless unless you don’t mind a 15 degree tilt running fore and aft of the side rail.