Sheet Metal Hand Seamer, 6 Inch Straight Jaw Bender Tools for Flattening Metal, Bending Pliers with Ergonomic TyreGrip Handle

Size is small but still works as intended. Also really useful tool to have around to bend metal like Toph….. anyways thank for the tool .

I am using this tool to assist in customizing gutter guard material. It is very useful in finishing the bends that are required and in flattening out the part between bends made with a larger bending tool. it has many uses when working with thin metal materials. It is an excellent addition to my tool chest.

This tool is well made. It does require considerable hand strength to both clamp and bend the sheet metal at the same time. I was bending 29 Ga (0.016") steel roofing along a 100+ inch line, and it's pretty tiring by the end. The best approach seems to be bending only a few degrees at first, to establish a line. Then on subsequent passes, stagger the jaw pattern to cover the unbent areas which want to warp. Clamping the jaws over these areas tends to flatten them back out. This approach results in more bending work, but provide a better-looking result than trying to do it all in one pass.

Seem well made and have proven to work well.

This is a great tool, worth the money and durability seems to be good, compared to more expensive brands like malco, I think it does just as good with a lot less money. We like it and it has been working great!

Good quality product. Allows me to bend nice 90 degree flanges for my ductwork transitions. Comfortable and easy to use. Definitely recommend for someone needing duct tools without paying the big distributor price.

Handles are little bigger than I’m used to but they work well.

So the seamer is heavy and overall appears to be well built. All the pivot points do not have any slop or looseness. The bad part is this tool is design to create straight bends, but the top and bottom jaw alignment on the front edge is not aligned. So if you do a bend down the crease will not align because they are off by almost 3/16". Since the jaws are cast the simplest way they could have corrected this would have been to just simply grind/file the front edges to a straight edge once assembled. Now I have to do that.

They work great, exactly as advertised.

I was fitting some metal flashing for a new roof and I was wondering how I was going to make some bends and still keep it looking sharp. I tried this tool out and it did a great job especially for the price. The bends were fairly easy to make and looked good. I applied masking tape and marked the fold line with a square and pencil, then just a squeeze and bend later and I have what I needed. If you mark the line in advance, you make sure the fold is in the right place and is upright.

As described

Me gusta el agarre al material y la posición de la mano permite ejercer buena presión

great product