48V POE Injector Adapter, 30W PoE Power Over Ethernet Supply,10/100Mbps IEEE802.3af/at, Compatible for Ubiquiti POE-48-24W, Amcrest/Hikvision/YI/Polycom/Aastra Camera and Phones

This works just fine for my Ubiquiti 6 lite, but be warned it's not gigabit. Clearly says so in the title, so shame on me for not paying attention. But other than that, serves it's purpose.

I use this to power a POE Wireless Attachment Point. It installs easily and does the job.

Arrived faster than Prime 2 day shipping so Love that! Also works as advertised, powered my IP Camera as expected. There's a very bright green LED power indicator that can be used as a night light or just turn it over and all is good. Very happy with the product and the RJ-45 ports are labeled clearly one side POE the other LAN so you know where each side goes. I use this mid-span to power an IP camera and LAN side on a Gigabit network switch and there are no issues at all. Very pleased and would order again from the same vendor.

This is 10/100 only! not Gigabit. This worked to power my IP camera which which only uses 4mb of data so gigabit is not needed. However, If I needed to power a switch or something with this, forget it. 100mb max. I will use these cheapies for cameras only and get a gigabit one for anything that uses more data. Time time will tell if these will last.

This is a great POE injector. I bought it to power my POE PTZ security camera. My camera can use up to 18W peak, and this is one of the few POE injectors that can output enough power for my camera. I went with a POE injector instead of a POE switch because a lot of the POE switches don't have enough juice to power all the security cameras that are connected to it. Be sure to check your POE power draw specification and the POE injector (or POE switch) power output. The hardware came very well packaged. The only complaint I have with this product is the LED is quite bright. It doesn't matter to me because it is installed under a desk so no one sees it. If it is too bright for your use, tape over it or flip it over so the LED faces down. It also comes with a nice 3-prong thick power cable. Overall, great product. I will be buying a couple more of this when I order my next set of POE cameras.

Arrived quickly, shipped in appropriate container which prevented any damage. I plugged it in and my camera SV3C came right up. I could not ask for more for such an inexpensive device. This saves me from having to pull power for receptacle at the point where i will mount this camera. I feel dumb for not ordering this thing sooner - will buy a couple more for other cameras.

I purchased this at the end of December 2024, it is now May 2025 and it no longer works. It is of course, out of the return window. I do not recommend.

I took a chance on this one instead of buying the Cisco/Meraki-branded injector because it was 1) cheaper, 2) overall glowing reviews which I'm sure can be trusted because it's the Internetz, and 3) YOLO. I don't know the quality longevity since I just started using it but so far so good.

Conforme aux attente

Very good quality and also good for ubiquity access points

Bonne qualité

This is a basic and fully functional POE injector. You plug one end of it into the wall and there are 2 ports, one is where you plug in your networking cable (input), and the other side is the combined POE output that merges the networking input with power. It has a detached power cord which is handy so it isn't a big brick that blocks the whole power outlet. The only downside is that this cannot be easily mounted to the wall or anything.

It is not 48v as advertised. It is in fact 24v.