KreemProducts TANK LINERPINT Chemical Other Fuel Tank LinerFor Sealing Gas Tanks - 1010

ALL YOU HAVE TO DO IS CLEAN TANK AND POUR KREEM IN TANK. THEN LET IT SET OVER NIGHT.

I was unable to find a replacement fuel bowl for an old tractor. Made of glass mine got broken. I epoxied mine together then because epoxy isn't fuel proof, I lined the bowl with this product. It worked as intended, even on glass.

I used this on a motorcycle tank that was over 30 years old. It was in amazing condition considering its age and really didnt need to be lined but I decided if its going to get repainted and custom mounts made, Im going to make sure its 100% reliable. It has a 5.5 gal volumn and I ended up using the entire pint in two sperate applications. You MUST follow directions. You must keep tabs on this product, dont let it pool up while drying and every ten minutes or so shake it and move it around to make contact with all surfaces. The finished product is nice and thick and clean. I have not tested the tank yet but I can tell just by looking inside with a flashlight it will work.Be sure to protect your paint. I did the relining while its in the primer stage so I can resand and clean it up but it will mess your paint up if it comes in contact for more than a minute. It will leave the lining compound on the paint and will also cause it to curl/craze.

I used this liner to seal a batch of leaky tiki torches. Every time I moved them around the patio, the torch fuel would pour out of the seams. It took days for the liner to fully cure. Make sure to remove the excess from visible areas before it cures. For example the liner leaked through the seams of the torch - which was expected - but I didn’t wipe off the excess at the time. It is REALLY hard to remove after it has cured. The only thing that seems to remove the excess is a razor blade. One bottle did 4 copper torches.

works great in motorcycle tanks. Good price here and very quick shipping. Thank you Amazon PRIME.

I used this product while rebuilding an 1986 ATV.Tank was so bad I considered replacing it with a plastic one - but after cleaning, blasting, welding, grinding it down - I only had a few pin hole leaks.I literally did 6 applications with the Kreem and also sprayed the tank outside with bed liner epoxy. So it basically is a complete hard liner within the inside and out.Easy to do - just don't rush the process and be meticulous. Allow plenty of time to cure between applications.With all the time I have in it, I could have purchased a new tank - but I saved about $200 and am very satisfied with the results.Prep is key with the product - don't cut corners and you should be more than pleased with the result.

No where in the description does it says that additional prep products are required for this to work! You only find out when you receive the product. An instruction card is wrapped around the package indicating that you need a cleaner and an metal prep product. What a bad surprise. That should have been noted on the description. Additionally, the product was not fulfilled by Amazon and is not returnable. So, be sure you you really want this. Or ping me. I have a bottle that will never be opened. :( What a rip off!

I refurbish old Maytag gas engines as a hobby and 'line' the gas tanks with this product. Use it in a well ventilated area. The tanks I coat with this product are small so I am able to use a 'throw away' brush and you have to work pretty quickly as the product 'sets' fast! I can coat 3 of the 'tanks' using this size of Kreem Tank Liner. I highly recomend this product, just use a little caution with ventilation and read the directions. Do Not use a foam brush with this product as it will melt.