TUSK 126-734-0001 Cargo Anchor
Product ID: 1596484
🔒Solid and secure design
🔗Cargo tie-down points
🛠️Fits multiple machines
Buy anything from 5,000+ international stores. One checkout price. No surprise fees. Join 2M+ shoppers on Desertcart.
Desertcart purchases this item on your behalf and handles shipping, customs, and support to Japan.
🚀 Anchor Your Adventure!
The TUSK 126-734-0001 Cargo Anchor is designed to enhance your vehicle's cargo capabilities by providing additional tie-down points. It fits a variety of machines, ensuring a secure hold for your gear, and is sold in pairs for customizable options. Installation is straightforward, utilizing existing holes in your cargo area for a hassle-free experience.
T**X
How to improve the function of the cargo anchor.
I purchased these based on the reviews and then once I recieved them realized I could improve them and make them more portable. First, disassemble them and add a "wingnut" next to the loop, then add the large washer, then the rubber, then the smaller washer and finally loctite the nut flush to the length of the threaded end. These can be inserted into any lock and ride portal and the wingnut can be used to tighten in place. Since the lower nut is loctited in place it will not rotate or rattle loose, the nut could be replaced with a nylock style nut if you like. Works great!
L**Y
Great tie-downs for Polaris RZR bed
These reasonably priced tie-down anchors install easily into most of the bed holes on my 2013 Polaris RZR. You must reach under the bed to install the large washer and nut. However, the underside of the center section of the bed is hard to reach because of the exhaust and other fittings. Next time I remove the bed I'll attach 2 more anchors. Great system, and super strong!
K**.
I got them to use in the bed of my Polaris RZR 570 and am very pleased. There was one stake pocket I couldn't access ...
These are simple to install, and will hold as much as the material they are anchored into. You do have to have access to the underside of where they are being installed to install, other wise it is a simple installation. I got them to use in the bed of my Polaris RZR 570 and am very pleased. There was one stake pocket I couldn't access from underneath, so I couldn't put one in there.
B**.
I put these on my Polaris XP. The washers ...
I put these on my Polaris XP. The washers are too big for the holes on the rack but that is ok as I believe it adds extra holding power on my ATV rack. I am going to add more to my back rack here in the future.
B**H
Perfect Solution to the lock and ride system. Good quality.
Bought 4 of these for a hunting trip. Used them on my 2008 polaris rzr 800. They are amazing. Easy to install and they hold tight. I put quite a bit of strain on them to really hold a gas can tight over very rocky and bumpy terrain and they didn't budge. Just bought 4 more because I liked them so much.
R**G
Will work until Polaris creates one that will be 30x the cost of these.
Since the RZR 570 does not have stand alone bed anchors, these fill the role just fine. You do have to take the nut and washer off, and hold them up from underneath to mount them, but they work.
C**R
Good quality part
Can’t beat the price - wish the eyes were welded. I like the wide bottom washer.
K**R
Good item.
I like this. It works will. I change the large bottom washer to smaller ones to allow inserting from the top. I would buy this product again.
Trustpilot
5 days ago
2 weeks ago