NooElec LaNA - Ultra Low-Noise Amplifier (LNA) Module for RF & Software Defined Radio (SDR) with Enclosure & Accessories. Wideband 20MHz-4000MHz Frequency Capability with Bias Tee & USB Power Options

I have been using my SDR (Software Defined Radio) RSPdx, with a Wide-Band Moonraker Discone Aerial and JIM M-75 GaAs Low Noise Pre-Amp combo. My SDR covers frequencies between 1KHz – 2GHz, whilst the Discone and M-75 each cover, more or less the same range of 20MHz – 2GHz. This arrangement has produced good results. The M-75, with Variable Gain, is connected at the receiver end of my 15m Down-Feed RG58 Coaxial cable. Due to Signal Quality degradation through coaxial cable, it seems the Best Practice is to amplify the Aerial Signal at the Aerial end rather than the Receiver end. Because of this, I decided to try the NooElec Active Wide-Band 20MHz-4GHz LaNA (Ultra-Low Noise Pre-Amp). The Build Quality of the NooElec LaNA is Very Good as is its cosmetic appearance. As the LaNA is an Active device, it requires power, which is derived from my SDR’s software activated 5v Bias-Tee feature. Obviously, the M-75 and LaNA cannot be used together, due to the way Bias-Tee operates. However, this really doesn’t matter, as the NooElec LaNA does a really great job, boosting the Gain of Received Signals. That said, the Gain is considerably more than I expected, requiring my SDR Software Gain levels to be reduced for certain Bands such as DAB. The NooElec LaNA with SMA Male-Male coupler, with power provided by my RSPdx Aerial-B Bias-Tee, which has worked perfectly over the last 5 weeks, does what it’s supposed to do and is now a permanent feature of my SDR-Discone set-up. Although it is slightly more expensive than some other brands, I think its Build Quality and Looks, as well as the USB, DC and Bias-Tee Power options, probably justify this. For all the reason above, I really do like this Device and feel it deserves 5 Stars.

I have a NESDR Smartee and it powers this lovely. It adds a decent amount of extra signal strength. 20db approx. I will be experimenting by adding a 20db attenuator based on a YouTube video showing further clarity improvements to drop the noise floor while helping boost signals. But as for this product as-is, it is good and works well.

It's a good amp. But, it does not power up on bias T from SDRplay RSPdx R2. Need to use powerbank or USB power adapter. EDIT... Died completely after a couple of months. Power light started to flicker then just went out. No longer amplifying.

It was really difficult to decide if to keep this or send it back. The spec says it should have worked with the 100ma Bias T output on my SDRPlay(1B) but it doesn't. It works fairly well on USB but due to the remote location of the PC and SDR its not ideal. You have to think carefully about how to use it but it definitely does the job. It's annoying that I can't switch it on and off remotely with the Bias T setting.

Pairing this with the Flamingo FM filter and an RTL SDR V4 with a dipole antenna, I am able to pick up ATIS from an airport almost 20 miles away with poor line of sight. Excellent and worth the money. Has adequate power using BIAS T.

This is the second one i've bought. I've used one with a little telescopic and a Flamingo+ filter and its the best, cheapest active scanner antenna there is, easily rivalling expensive name brands. The design is really cool too. Highly recommend.

Works like a charm! I have purchased cheaper versions and they were rubbish to say the least! Nooelec in my opinion are the best brand to buy for SDR Radios. Whether it be an LNA or a Dongle.

Not happy with this LNA. It didn’t appear to boost the signal too well and then the SMA connector pin became bent. I have never damaged any equipment before and I put it down to poor build quality. Maybe I was unlucky with this unit, but you may also have a poor quality control unit

Ce produit est bien. Je l'ai utilisé avec ma clé SDR V.3 et un fil de cuivre de 4,25 m. Le LaNA, avec le Bias-T activé, nettoie tous les parasites et amplifie le signal. plus de grésillement !

If used for wide-band signal measurements; be sure to compensate for the frequency characteristic of this LNA by measuring that characteristic with the same equipment.

Non riuscivo a farlo funzionare in quanto la tensione di 5 Volts è ,per il mio sistema , eccessiva. L'ho ridotta ad 1 solo volt con un bias T esterno riducendo il guadagno. Se salgo verso la tensione di 5 volts il ricevitore diventa sordo con tantissimo rumore. Antenna discone Diamond D3000 , LNA Nooelec Lana, 10m Messi e Paoloni 7 , SDRPlay 2 ch.A e software SDRV3 Console. Molto soddisfatto per la sensibilità ma sopratutto per il rapporto segnale rumore. E' consigliabile piazzare l' lna subito dopo l'antenna.

Spodziewałem się obłej Lany z wejściem zasilania mini USB, a tu przyszła kanciasta z dziurką na wtyk USB-C - ewidentnie nowa wersja, o której w ogóle nie słyszałem. Do tego porządny giętki półmetrowy przewód zasilania z wtykiem USB-C, adapter do typowego okrągłego wtyku od zasilacza i adapter SMAm > SMAm. Pierwszy, szybki test wykazał, że wzmacniacz rzeczywiście jest niskoszumny :), a na konkretniejsze wnioski przyjdzie czas, gdy dotrze do mnie filtr Flamingo+.

特性をnanoVNAで測定してみました ゲインは10dB程度で低めに出ていますが周波数特性は特に低周波数側は 3MHz程度まで使えそうです（短波帯の受信での確認はしていません） 実際の受信は144MHzのアマ無線、FM放送波、ADS-Bの受信でしか確認していませんが何れも良好です ダイナミックレンジが広いようで広帯域のアンテナを使った場合でも特にフィルタなしでも受信が改善されるのは良いですね