JessEmMast-R-Top 24" x 32" Phenolic Router Table Top, JessEm# 03006

This is dead flat . If you have ever price Phenolic you would know you can't buy raw material of the same thickness (3/4) . It is well made . Great substitute for an iron top .Also was boxed well to protect the edges from getting damaged. The top is heavy . Phenolic is dense material.

Everythin about this router table is top notch. I did not, however, receive one part. Apparently this is not uncommon as I have seen several customers say they did not receive everything in the box. Too bad. Fortunately, my missing part was not critical as that would be a hassel. I will contact Jessem support to see if they will sent the missing item. If not I will still be okay with it.

Many years ago, I built my own router table cabinet and top. Recently I checked and the top was no longer flat (a 1/16" or more off), so I got this top to replace the one I had made (I also got a JessEm router lift). I have a Bridge City Toolworks 24" straightedge, I checked the top and it was flat. It came with mounting screws and a Torx wrench (a nice touch) and I easily mounted it onto my existing cabinet.I didn't get the JessEm router table fence, I used my own shop-built fence, so I have no experience with their fence on the table. My fence grips the bottom of the table to lock in position, and it works well with this table.After putting in the JessEm router lift and my Bosch 1617 EVS router, the top is still flat (to better than .004") several weeks later. The table has not sagged. The plate that is part of the JessEm router lift fits well into this table and there are two screws to snug the plate to the top. (I mention their router lift as others may wish to get both a top and lift from the same source.)I'm very happy with the router table top.

fits jessum router perfect

Ordered mine on a sunday and received it 3 days later, a full week ahead of the estimated delivery. Jessem makes great quality products and this was nothing short of that. I bought the incra (jessem master lift II) to go with it and the jessem fence (woodwerks) to go with it. with all the discounts I saved a couple of hundred dollars building it myself. highly recommend jessem products. hard to go wrong with them. I believe I must of gotten the last one they had in stock......sorry.

this is the second Jessem router table I have... flat, stable, slick.. in other words GREAT! also have two Mast-r-lifts and two mast-r-fence all greate

I am in the process of building my own router cabinet on casters and chose this top along with a Jessem Master Fence II and Jessem Master Lift setup. I immediately checked the table upon arrival and found that it was well made, undamaged, and nearly flat. I would say that it is within 1/32" an inch of being flat across the entire surface, both width and lengthwise. Reasonably flat for anything other than cast iron.The problem though: The table is pre-drilled with a variety of hole patterns on the bottom to accept either the Jessem steel stand or your own setup. Not a single hole was threaded. I also received no bolts or hardware with the product. Just a set of poorly worded instructions loosely referencing 6mm bolts that were supposed to come with it, leading me to believe that the holes should be threaded for 6mm x 1.0 threads. I had to hand tap the 8 holes needed to mount the Master Fence system, and the 14 holes necessary to secure the table to my cabinet. I do not blame the seller for this, as this is clearly a manufacturer's defect, and I am not leaving a bad seller rating either. It is a minor inconvenience to have to tap the holes, but a pretty major oversight in Jessem's quality control.

This router table top is exactly as advertised and is machined perfectly for JessEm lift plate and fence. Plenty of self tapping screws included along with the tool to install them.