(8pcs) Fuel Injector Connector for EV6 EV14 USCAR Pigtail Harness Socket Plug Wire for LS2 LS3 LS7 GM Ford Dodge Jeep Mustang Vehicles Bosch

Worked great. These connectors were perfect for replacing my dry rotted injector plugs that were shorting out.

I had to purchase this set of pigtails when I replaced the fuel injectors on my 2006 Jeep Rubicon Unlimited 4.0I replaced my stock injectors with the Bosch 4 hole. I had some cracked wiring so I ordered this set knowing I would have a couple left over for the future. I included a picture of my stock connector and the Bosch injector. When you get these pigtails you will want to check the red wire/black wire position. It was reversed on one of the connectors. I included a picture. Since I had 8 and only needed 6 it worked out fine. When wiring these to your vehicle just pay attention to the old connector and connect it to the new one the same way. I did it one at a time and took my time and had no problems. These connectors do not have the red clip that the stock Jeep connectors have. They click/snap into place so I don’t have any worries about them staying connected

OEM 2008 Ford Expedition factory wire broke off- likely due to heat and age. Purchased this based on reviews. Love that there are reasonably long lead wires- I needed that extra length to repair. Soldering into the factory wire harness took 10 minutes. A bit of heat shrink and some electrical tape, back to normal. These fit perfect. Cleared the code for engine misfire and runs like it should. Still have 7 more in case I run into issue on s other cylinder.

Didn’t fit what I ordered them for, but was well constructed.

Worked like a charm. Very happy with these. I installed these on my 2001 Jeep Cherokee XJ. The wires had eaten through the insulation and was causing them to short. It wouldn’t start, just crank. And it also kept blowing the fuse that control the injectors. I also added some heat shrink to the wires so it’ll help out some more on keeping them separated. I would recommend these if you need new connectors. For my truck, the black wire on the new connectors became the power wire and the red is the ground. Use a wiring diagram to help you out if it’s your first time doing something like this.

I had to replace 3 out of 8, that a previous mechanic shop butchered on one of my customers cars... more cost effective to buy the set of 8, than just the 3 I needed...

I found these connectors would not fully seat on my fuel injectors. Further inspection found, unlike in the picture of the product, there is not the “window” at the top so the connector can clear the body. I was able to cut them to fit though. Top in my pic is how they came, bottom one is after cutting to be able to fit.

Bought these to replace some clips I broke while pulling my intake. I defined these and retained the factory wiring, there are videos how to on YouTube. Worked great. Would recommend