3M Safety-Walk Slip Resistant Tape, Black, 4 in x 15 ft Roll

The tape seems to stick very well. It was easy to cut into strips and apply to my ramp boards.

These met our needs nicely and improved both the look and safety of our stairs. They seemed to adhere well, though we had little time to know how they would wear over time.

Good adhesive and easy to install on indoor flat metal surface (entry threshold). Thick and fairly heavy like tar paper or flexible shingle, similar to what I was hoping for from the more expensive 3m product. This has embedded sand, probably similar or more coarse than 60 grit sandpaper. A flexible asphalt shingle tape is how I would describe it.

Bought 4 rolls of the safety tread and all 4 boxes arrived looking as if they had been tossed around in a warehouse for the last decade. I also used 3M spray adhesive to bond the tread to my deck surface just in case the adhesive backing was ineffective. So far it’s holding fine a providing the traction needed on the decks steps.

So far, so good. Rounded corners off, used spray adhesive. No roller but heavy enough my feet did the tamping down quite efficiently. Mom wished they had the glow in the dark strip, but the ones that did were not as heavy duty and for outside steps, cheaper is just that...cheaper.

good deal

You needed sharp tool to cut it. I put it on and 2are coming up already. Looks great. Was easy to install

I am using these on the ramp of an enclosed trailer. Especially in the snow, the ramp was extremely slippery, as was the aluminum transition flap at the top of the ramp. I placed strips of this tape across the full width of the ramp, spaced every 12". The adhesive has held up well under rain, sun, and snowy conditions, and sticks securely both to the wood of the ramp and the aluminum transition flap. For installation, sweep and dust the surface thoroughly. Mark guidelines on the surface to help your alignment when applying. Use a roller to press down the product after placement. Or, without a roller, walk solidly on every square inch of the applied tape so that the adhesive is well engaged with the surface. Tip: for this tape (and many other tapes & stickers) you can improve the longevity by rounding the corners before you put it on. Keep those corners and the rest of the ends as clean as you possibly can while installing. If you are going to get fingerprints anywhere, do it somewhere in the middle of the tape. This means that you can get better results if you remove that backing paper starting in the middle, rather than at an end.

I bought the 4 inch tape to cover an area on my running board that the paint had worn off from me not stepping on the tread. It worked perfectly. My only advice is make sure you put it on right the first time. There ain’t no pulling it off to reposition it. It works great and is very easy to install.

Best non slip tape on the market in my opinion - does not lift after a few months. Top quality product. One thing - I wish they would hold the roll with (say) a rubber band instead of thick glue that can't be removed and you lose some of the tape as you have to cut off 2 pieces that are glued at the end.

I cut out pieces ans installed it in the door seal of my F150. Easy to cut with cisors. Really sticks on. Looks factory. Strongly recommend.

Installed on plastic steps . Used contact cement as recommended. The dog and I have better wet / snow traction.

service and item both great. thank you