LivTee Universal 8" Flexible LED Light Strip with Tail Brake Stop Turn Signal Lights All-in-one for Motorcycle Scooter Quad Cruiser Off Road, Red/Amber

Installed these lights on my saddle bags to add more visibility to the back of my motorcycle. Adhesion sucks on the ends of these lights, especially if you are following a contour. Used a little bit of loc tight glue to secure them. They bent enough for my application, so no issues there.As others have stated, the wires are super small, I soldered my connections and then used heat shrink. They are bright and work well for my application. The red running lights do overpower the amber turn signals. I wired mine to utilize both blinker functions within the light for each side( just tie yellow and green wires together). I did not take my main turn signals out so it wasn’t that big of a deal to me. However, I wish the amber scrolled across the length of the light when having the turn signal on. You can get this function in led strips it just cost more. All in all , great for the money spent and my purpose.

Remarkable that it works as well as it does. Lights bright, easy to install.

It works, it's bright, and it's cheap, only issue is the wires are so thin I had to use a magnifying glass to see them, this also makes them fragile. Make wires thicker and it's 5 stars!

Fairly easy install with a test light. I wish the wires were a little thicker only to make it easier to use crimp-on connectors or any other connectors at all. I broke out the soldering iron to complete this install. Its fairly thin and sends out some decent light for a motorcycle or other small vehicle. The double sided tape seems to be holding pretty good but its only been a couple weeks. I added a couple zip ties as a precaution. The amber turn signals are pretty visible, not a bad install. I just hope its still working months from now!

Good

LED’s can’t be seen at day time..Wires so small that the smallest setting on wire strippers don’t work..After stripping with knife wires are barely thick enough to be soldered to original wire harness..Wires so tiny that they break an inch back from solder joint during wire management.. each wire snapped several times so now it’s too short to wire!

Slim and sleek design. Sticks pretty well if you pre heat the surface you are sticking to. Running light and brake light worked great. Nice and bright. Blinkers didnt work though. Wires are ridiculously small. Have to be very careful splicing

I give 5 stars overall, after all it was only $11.00. What's $11.00 these days for tail, brake, and turn signals all combined. It does work and it's bright.In my case, I use it for a motorcycle. It is brighter than the led strip it replaced. It was easy to wire. I gave 3 stars about adhesion. I had to use a bead of jb weld super glue to fasten it well. No big deal, but I did ,so 3 stars on adhesion. I agree with previous reviewer who stated the brake light is so bright that it obscures turn signals, but that's not a big deal. Most of the time on my motorcycle when the turn signals are on the brake light isn't anyway.It's well worth $11.00.