DeVilbiss OEM D24595 Air Compressor Fan C2025 919-16737-CA D55141-CA D55141 C2000-WK-CA 0 COMPRESSOR CFFN250T-CA CP503-CA HFAC3030-CA C2004-WK PCFP02003-CA COMPRESSOR/NAILER 1 TOOL COMBO KIT -

This fit my craftsman 919167244 compressor.

This product worked great as a replacement part for my broken part.

Took compressor housing apart and put all screws on a piece of cardboard to position them where they went. Arbor opening on fan is really a little small. Heated it up with an old soldiering iron. Took some pounding with a rubber/plastic mallet and continual heating. Last bit of getting it to seat far enough on to put the locking ring on I used a long socket to get it further onto the shaft. Bit of caution, don't breath the fumes from the plastic or get the smoke in your eyes. Didn't want to drill out the opening since the shaft is serrated and the fan needs a tight fit on the shaft. Good thing it worked to fix the compressor after my son in law let a drawstring get into the old fan and shredded the blades. It was an older compressor I had given him. Enclosed measurements for further buyers since sellers don't seem to understand that numerous measurements are needed to see if it fits different compressors.

I bought the 6gal "Hyper Tough" compressor from Walmart, but a lot of retailers sell the same model under different names. The bolts holding the compressor worked loose and the fan destroyed itself on the housing. The old fan is simply pressed on.This replacement fan looks identical to the original, except I had to drill out the mounting hole in order to get it to fit the shaft. Careful not to ream too much, there is a knurling on the shaft to keep it from coming loose. There is a snap ring to insure it doesn't come off.

Works for DeWalt compressor DWFP55126 perfect fit easy installation.

Used it to replace a fan on fortress 6 gal pancake compressor. Had to drill out the center just slightly and then tapped it on with a hammer.

This Replaced a fan on a Ridgid OF60150HBTYou do have to take the time to get the old one part off with care. Dont yank on the armature which is also the compressor crankshaft I used a hacksaw carefully.. To cut a section off the old fan blade center " hub," and the rest came off easily.This new part I heated the center briefly with a lighter and it pressed right onto the shaft. Lil tap from a plastic mallet. Screw it back together and get to work.

The fan I was sent did not have the dimension that were shown on the ad. So, I can't use it and I haven't found out how to return it or exchange it for what I need because no one is responding to my inquiries.