Motor Guard M-100-KIT 1/2 NPT Clean Air Filter Kit

Probably the best particulate filter available at a reasonable price. Works great. Last one lasted over 15 years on a system used daily.

Great quality

Works great! Recommend this product to all DIY’s!

Sturdy with good surface area on the filter, but there’s no hard points to make this easy to mount unless you are mounting it inline in a rigid line. The mounting bracket listed as going with this on the Amazon page doesn’t fit this model. You’ll have to make your own bracket if you have flexible lines. Be sure the rubber seal is correctly seated and tighten the top firmly or the seal can easily leak under pressure. Overall I’m happy with the good flow and lack of restriction in my air line. Filtering is very good.

It said it will be days before I received it. Not happy, but saved 2+ more dollars and not in a rush. See 5 stars I left. Don't work for them, run the everlast welding forum. The due on Aug 4, received Jul 28 AM. And a better price than tooltopia too, so really happy now (they were the lowest outside of these guys).. But I heard tolltopia is good. The quality is great. Aluminum case. I did the 1/2" npt and bought reducers, per someone on our welding forum. Ran to homedepot (lowes has them too) and picked up 1/4"F to 1/2"M npt adapter (2 for about $8; HUSKEY SKU 368 081). Better volume for about the same price (m30 vs m60). 3 filters with it (they name it M100 with the filters, it's M60 with 3 filters). I have a small dryer in front of it too. Filters, I've heard you can use TP (toilet paper rolls) in it (one online comment and two real friend with paint shops). Also you can dry the old factory filters as well (what I will do). It will be use 24/7 for now on the compressor (tools, cutter, painting, fill a tire, whatever). But main reason was for plasma cutting. My homemade whole house disicant (sp) filter installed only when cutting, blew up and hurt me a bit (PSI was 120 or so and did not lower PSI; did not think about it one day and boom). Go this way please. The cost is not a lot more and the aluminum will split, plastic (whole house homemade) will throw pieces when they blow, cut you and bruise you good (trust me one that part).

Actually arrived early. I did have to get a couple fittings locally to adapt it to my plasma cutter but it will remove all the contaminates and moisture from the air supply to my plasma cutter which will greatly extend consumable life and plasma cutter consumables are expensive. I recommend it for any plasma cutter, good insurance against failure from entrained moisture in the air supply. It actually came with one sub micronic filter installed in the housing and 2 more extra filters in the package for a total of 3. The clamping lid was extremely tight when I received it and I had to loosen it in a vise, way too tight. I just applied a light coating of Vaseline to the internal rubber gasket and finger tighten the top lid to the bottom section and it seals just fine. Keep in mind that it's rated at 125 PSI maximum pressure so if your air supply is above 125 PSI, you will need a pressure regulator post filter but then most plasma cutters only require 125 PSI air anyway.

It seams like a Quality product.

This thing really does a great job of keeping water out of your line.

Works amazing on my plasma table, its used in conjuction with other air dryers and filters but great on its own!

Creo que fue muy buena compra, muy buena calidad de filtrado.

Super bon a mettre avec du papier de toilette

Bueno

Great filter, it just works. Better than anything I tried before.