Lehigh Crawford Flip Up Tool Holder NoFTH3P (3-(Pack))

These are sturdy, I usually get 3-4 handled tools to hang on them. They are easy to install, drill a pilot hole and then screw the hd screw in. They come with the needed screws. They look decent. These are my favorites, I have about a half dozen installed between the house & barn.

Heavy duty. Wide enough for any of my shovels. Just a little too tall to install on 2x4 rail but will fit 2x6 rail fine. Installs to stud just fine.

This product is tough and durable. The description is accurate. I purchased them to hang both wreaths and tools.

Nice brackets. Used them to organize my garden tools. Can hold items to the full length. Used the screws that came with the brackets. Wished they would have been hex heads instead of phillips. I would buy them again.

Great quality and good price.

Great product

Mounted easily to studs in the shed. Holds shovels, rakes, loppers and some power tools. Sturdy.

I bought several of these shovel/tool holders. And would buy more. But...I had to drive to hardware store to buy a "special" screw driver bit. The screws sent are a problem. Those phillips-head screws do not fit the phillips screw bits or screwdrivers that I use for 99% of all my phillips-head needs over the past 50 years (a PH-2 bit). I was unable to drive the provided screws into dimension lumber, even with a pilot hole, without stripping the head. But worked out well after driving to hardware store to buy a 69c !!! PH-3 bit, which fit just fine. See attached photos.BTW: These holders are much stronger than I hoped. Rated 50 lbs, and I believe it. I hung 5 shovels from one holder, saving gobs of prior space. (But only if, you drive to hardware store to get special screw driver or bit).