Barrina LED Shop Lights, 8FT 72W 10000LM 5000K, Daylight White, V Shape, Clear Cover, High Output, Linkable, T8 LED Tube Light, for Garage 8 Foot with Plug (Pack of 10)

These are easy to install and bright. The screws are a bit cheap. Not a surprise. I used some self tapping screws. Easy change out. I only used 2 clips per light. Seem to be good. I have them in a barn and they seem to be just fine. These have 4 feet connectors. Not very far. I would order the 10 footers to go with it. You also get a mess of cords that you can hard wire with. If you are not putting them on a switch you can wire on a male end and it will plug into an extension cord. The package doesn’t come with any male fittings. Remember they are 20 bucks a light. They are good for the money. We bought another pack to finish the job and have some leftover when one goes out. They should just replace easily. Time will tell.

Just finished installing 8’ and 4’ lights in my garage. The different length lights link up just fine and the most I have in a single string is 3 (one 8’ and two 4’). They are lighting up my 3 car garage and put out more than enough light to work anywhere within the garage at 4’ spacing. I added additional junction boxes down the middle of my garage to keep the amount of linked lights down since there are restrictions on how many can be direct linked. There are good and bad things with these lights. The good: - The lights are bright and easy to install. 1 clip for each 2’ of light is what I installed at (4 for the 8’ fixture, 2 for the 4’ fixtures. - Cannot beat the price. We will see how long they last. The bad: - They say you can hardwire them. I think they meant “hard to wire” them. The lead they give you in the box for hardwiring is +\- 6” long. The stub of the three stranded wires is only stripped 1.” Anyone who has ever done anything inside a junction box knows that is way too short to easily work with. The stranded three wires coming off the white jacket needs to be 6” long, not the 1” they give you. Fitting three caps inside a j box with 1” of cable separation between load, neutral, and ground is hard, even using Wagos. Stripping the jacket leads to damaged conductors very easily if you aren’t careful… but then that leaves you with basically no room to connect to the fixture. Your Jbox has to be within 3” of the fixture connector. - heat sink and clip. The aluminum chassis that is also the structural back of the fixture is also the LED heat sink. It gets pretty warm. Hind sight being 20/20, I would have opted to mount the brackets with some spacers to get some space between the back of the fixture and my wood joists. I’m not too worried about the heat, but more about the fixture being able to dissipate heat efficiently. - the screws. Go to your big box store and get some proper screws. The tofu pot metal garbage screws they give you strip out very easily. Save yourself some curse words and just pick up a pack of decent screws. - the diffuser. Or lack there of. Nothing like getting glared by direct exposure to LED diodes. It would be nice to have a frosted lens option, even at the cost of illumination reduction. Other thoughts: Not dimmable. Tried hooking up a dimmable Lutron Caseta smart switch. The switch instantly started buzzing and shortly thereafter, the switch went into thermal shutdown. Works fine on a dumb switch. The 4’ cables to link strings cannot link up directly, so don’t think of putting two together and having an 8’ spacing between linked lights. The connectors have to go through a light fixture.

These lights were purchased to be installed as garage lights. I am amazed at how bright these lights truly are. I did not install all of the lights and my garage is fully lit up! They were easy to install - did not need to use directions, however directions are included. They could be installed individually or linked together. I linked mine together so when I turn on the switch - the sun is on in the garage. The great thing is - the lights are smaller than the old shop lights that I removed from the garage! I am impressed with the quality and brightness of these lights. I am adding some to my chicken coop and barn. I would recommend!

I installed 12 of these 8’ lights in a 40’x40’x12’ pole barn. Granted, they have only been on for a few hours as I mounted the rest of them, but so far, I’m very pleased! These are the 5k color lights. I have included a video that shows 6 of them on and then all 12 so you can see the lighting coverage for my building. Installation was a breeze! Mount the clips and push the light into place. Be aware that these lights aren’t a “true” 96” length, so if you are running them between trusses and have 4’ on center like I did, you’ll want to mount them to the truss itself as shown. Also, this product doesn’t come with plug-in adapters, so you’ll have to hard wire one of the plugs to test the lights before installation. I knew this ahead of time but wanted to remind potential buyers. All-in-all, these are great quality and well worth the money spent! They look awesome in the space and provide the amount of lighting I was looking for. Great functionality for the price!

I ordered over 32 light strip for myself and all my family followed early on because these are incredible lighting solution. 5000K is a good temperature to get great color accuracy and comfort when working. The installation couldn't be easier (small clips with simple screws, then clip on the led strip). They are insanely BRIGHT and you have the option to use regular IEC15 plug with integrated switch or you can hardwire them. The only (small) downside I may share is that the hardwire wire provided is quite short but since you can always use the regular plug and cut it to length, this not a real issue. I used them for more than 6 months now and never experienced early failure. Oh and I forgot to mention you can piggy-back up to 5 strips together so this is another easy way to get A LOT of light very quickly and simply. Pros: - Very Bright - Easy to install - Not expensive in regards to the quality - Can be bought in 4ft or 8ft strip - They will probably last a long time - not prone to early failure in case of regular on/off (compared to regular ballast/tube) - can be hooked together (up to 5 at once) Cons: - Hardwire a little bit short Watch out for coupons as these are seen regularly on sale.

After replacing my flickering fluorescent tubes with these Barrina LED shop lights, my 2-car garage now looks like a professional workshop—with zero humming or warm-up time. The 10-pack was the perfect amount to fully illuminate every corner. Why These Earn 5 Stars: ✔ Instant Daylight Clarity – 5000LM at 5000K eliminates shadows (perfect for detailing cars or DIY projects). ✔ Linkable Design – Daisy-chained 6 lights together with included connectors (saved hours of wiring). ✔ Durable & Efficient – 40W draw slashed my energy bill vs. old tubes (and the clear cover diffuses light evenly). ✔ Easy Installation – Mounted with included chains or direct screws (took 15 minutes for all 10). Real-World Testing: Garage: Covered 400 sq ft with 8 lights (2 left for spare). Workshop: Survived sawdust and vibrations from power tools. Costco Test: Compared to $50/unit brand-name lights—these deliver 90% of the quality at 1/3 the price. Perfect For: ✓ Garages/workshops ✓ Grow rooms (even light distribution) ✓ Retail/store lighting Pro Tip: Space them 4-5 feet apart for seamless coverage! 10/10 Recommend – The best value in shop lighting I’ve found.

These lights are great! Bright and easy to install. Only thing I can comment negatively on, is the hard wire pigtails are way too short. I have owned these since nov 2022, and have had some of the lights begin to fail. I reached out to barrina customer service and they are sending replacements and honouring the 3 year warranty without any hesitation. Great product that the manufacturer is standing behind!

Installed these in my 30'x30' home gym with 10' ceiling. Installation was relatively easy. The supplied brackets allow the lights to snap into the ceiling. The fit is tight but secure. For the long 8' lights I recommend at least 4 brackets. There are cables included for plugging into 110v wall outlets, connecting to existing ceiling wiring, and connecting one light unit to another light unit using c5 connectors. The lights themselves are pretty simple. They are bright. They heat up a bit but not enough to cause concern. The are slightly diffused but I wouldn't want one directly above me if I were on my back looking up. I wasn't finished my renovation when the lights arrived but having the standard wall connector allowed me to use many of the lights around the worksite. Bonus. Would I get these again? Yes I would.

Easy install, super bright light. If I was to complain about anything, it would only be the length of the jumper wires to connect them with. Just wish they were a bit longer, but I made it work.