Signature S40008B 9” 2 Speed Desk Fan with Oscillation, Adjustable Tilt, Black

Great fan!! I’ve spent ages choosing and was thinking to buy much more expensive one but got this one as it’s just for the heat wave. Arrived promptly well packaged. Easy to assemble. Most importantly it’s cooling the room very well. Not noisy imo and powerful. Great value. Thanks

If I could give this item 0 stars, I would. Seriously, do not waste your money, these are the worst fans I’ve ever bought. I optimistically bought 3, I’ve had to return all 3. One had nowhere near enough power to actually blow barely any air out, at all, and its buttons were not working properly so turning it back off was a pain. One was seriously over heating after 1min use and was making the worst high pitched squeaking noise you could imagine. One actually seemed ok, and we didn’t think we were going to have to return it..until it had been on for 30mins, and then it too was overheating and even worse, the blade fell off entirely while the fan was on and the fan’s cage had to be taken apart to put the blade back on. Absolutely trash.

Worth for money

You get what you pay for, I read the reviews here and was worried about the noise levels and lack of airflow, It had the same issues also the over heating. As there were no instructions manuals I had to look at the parts that came with the pack. The blade seems to no fit the spinning spigot properly and there is a lot of heat build up because the blade is not spinning in sync with the spigot, There is a little spring like coil in the accessories bag, that needs to be fitted at the back of the blade (with pressure) before the blade is inserted (Hard Press Fit) to the spigot, if that blade goes in easily the fit is too loose and you will get the heat, reduce flow and noise. Law and behold the airflow increased and the rattling noise completely went away. The blade should be spinning in sync and the fit needs to be tight by means of the little coil to ensure no slippage of the blade, not the strongest fan but it is a two speed. Sufficient for the value in my opinion. I did a before and after, Noise and flow changed after fitting it correctly, instructions manuals would have been fantastic.

I had trouble initially with this fan as it wasn't working as it should, I then realised it was loose where the plastic blades slip onto the metal pole. I glued it on (using no more nails) and it's fine now, no noise and running properly! Yay! Basically a cheap fan thats not made brilliantly but a bit of glue totally sorted it!

Instructions were really rubbish and led to a difficult build of the fan, should have been simple. First thoughts , an ok fan quite powerful and quiet. After a few hours of running it started to make a horrid squeal , happens when in motion and static. Would I buy again? No I wouldn’t.

Good

This fan is absolutely horrible, I purchased 2 of these fans and on the first day of usage, the first one would not spin properly without making lots of noise. When I used my second one of these fans, it took a week before it stopped spinning, and the insides of the fan began to melt, and the fan blade would fly off of the fan. It smelt like burning when I had it on. it is too loud to use at night. Please do not buy this fan unless you want to have a hazard in your house. I would rate this as 0 stars if I could.