Description
- Wave Length: 450nm , Fixed Focus(not focusable) , 12V. Size: 40x70mm(please check if your machine can hold this size of laser!!!!!)
- Frequency: <15khz, PWM/TTL: 0-5V , Please add a fan when engraving or cutting, in case smoke damage its lens.
- When you connect laser to your controller board, please pay attention to the pin positions of 12v+ GND- and PWM/TTL, red wire=12V+, black wire=GND-. Yello wire=PWM+, white wire=PWM-(3-4pin wire). So Red Wire must be connected to the 12v+ pin on your controller board’s interface, Black Wire Must be connected to the GND- pin and Yellow Wire must be connected to the PWM/TTL pin, if you use 3-4pin wire, White wire should be connected to the PWM- pin.
- if your controller board’s laser interface pins are in different position, please change the wires position to make it match the positions of + - PWM of your interface. If the wires connected wrong, it will damage the diode and the driver board.
- this 15W laser focus length is 1.8CM , for engraving and cutting only!
- ›See more product details
Technical Parameters: Laser wavelength: 445nm-450nm blue laser Spot type: retangle spot (fixed focus, NOT FOCUSABLE) Focus Length: 1.8cmOutput power: 15W . this laser is fixed focus (not focusable) , for engraving and cutting only. can mark on stainless steel, and cut 3mm plywood very powerful ) Size: 40*70mm Drive mode: external ACC constant current drive Cooling method: forced air cooling Operating voltage: 12V DC Shell material: aluminum, surface anodized Collimator lens: optical glass coating THIS IS NOT A FOCUSABLE LASER, this laser is for CNC laser engraving machine or laser cutter only!! PACKING LIST: LASER*1 3PIN CABLE*1 3pin-4pin wire*1 SAFETY GLASSES*1
