Eiechip Mini Breadboard kit 170 Points Mini Small solderless breadboard for Proto Shield (6 Colors 6Pcs)

There are no numbers/letters on any of them, also cheap plastic used. Terrible compared to other ones I've bought off here. To make the cosmetics seem like a non-issue, two of the six boards I found out (too late to return them, mind you) had bent internal pins that werent making conductivity when they should have. I just moved 1 row over to continue on with my project, but still...... These are junk.Tldr;Dont waste your money on these like I did

Maybe I'm a little dumb but when I first ordered them I was a little annoyed because I thought the wires just had to be in groups of 40. To my delight, I found out that each wire can be peeled away from the rest so you have 120 separate wires (maybe I should've known that from the beginning).

Great product for testing your circuits!! Do not use for actual robot. Resistors will fall out if not inserted properly.I think the rails should be made a little better. My wire go in sideways sometimes. They also spread the rails so there’s a possibility of two adjacent rails contacting each other. (Causes a short)

These make great extension and connector wires. I even use them for motherboard extension cables (like cmos reset)

Great product. Value for your buck.

So far so good, recently used to prototype a discrete circuit. A lot easier than soldering etc particularly when changing component values to achieve end goals.

Work as you would expect a breadboard to work, no issues with durability or quality.

Compact and pins easily connect with wires. Small enough to toss on top of any dev board or shield without fumbling around.