electriQ 60cm Stainless Steel Visor Hood with Glass Front - Top & Rear Venting - 5 Year Warranty

We bought this unit to replace an old extractor that was well passed its better days. As it's constructed from Stainless steel, it looks great, and the controls are simple. All in all, a very good product. Would recommend.

Quite thin metal but good enough quality and extracts well. Versatile unit with top or rear fitting. Instructions state two required to fit but easy enough for one person

Don't know yet

Exactly what I was looking for, delivered on time, good price - no complaints

Had a situation where I our kitchen wall units needed to be replaced and elected to also change the cooker hood. This was purchased to replace a very good (but seriously old and bulky Neff cooker hood) First, I am attempting to be objective and not directly compare, as the old unit had I feel a better fixing method and very powerful (but noisy) fan along with being heavy guage metal built to last... Nevertheless having checked out a few similar (a couple cheaper and many more expensive) hoods, this fits the bill. It is very light and reasonably slim, with grease trap panels that are washable (seems standard today). It does not come with the carbon filter but this can be purchased separately (and is a bit pricey) Suction seems fine (we only use it on setting 1 and its fine - noise is less than previous and not too intrusive albeit set on 1. As mentioned earlier the recommended carbon filter I feel, is a little pricey and not sure if a cheaper product will fit (as the centre connections seems to vary) So hence why not 5 stars. If a little care and thought is taken to install then should have no issues. It comes with a fitted plug and I initially thought would be a problem as fitting under a wall unit - but then remembered wall units have a gap at the back! so was able to run with some pre-measured cut outs on wall unit back to plug outlet. If this will not work for you then either disconnect from motor unit internal and run a new cable or simply cut off the plug..

Does it’s job

Good bit of kit, was a bit of a pain to install

It simply isn’t square. As soon as I unboxed. Bits warped and twisted, screws not tightened up. I had to remove the two fan securing screws because the other side had fallen out of its tab…. If I wasn’t so desperate to replace the old one I’d have sent it straight back. For £65 I don’t feel it’s worth it at all. It’s utterly unsafe to knock the back out even with the proper tools. The plate tears and you are left with dangerously unsafe bits of metal, presumably because the press didn’t create the cuts properly. A small slip while removing that and your off to a pharmacist for a bandage. Operation wise It’s not too loud and the suction is adequate enough. Front led sheds lots of light so that’s ok. But looks like it can’t be changed.