MGP Brake Caliper Covers for Chevrolet Corvette 1997-2004 with Red Powder Coat Finish Engraved Silver Corvette Logo, Front and Rear Caliper Cover (Set of 4)

I needed some way to cut down on the dust that gets on the rims especially the front from driving only 50 miles or so. I looked at a few videos of these caliper covers and decided to get them. They really changed the appearance of the brake calipers, mine were chipping the paint off and I didn't want to go the extra mile and remove plus paint with all the masking and everything. These are not replica brake calipers, they are caliper covers for dust, so to the ignorant people that post stupid comments about these covers, just ignore them and get them if you choose, I did and I'm happy cause it cuts down the brake dust and I spend less time now cleaning the rims.

Installed on my C5 2004 Corvette. I went with the covers instead of paint mainly because of time and mess. I have the OEM rims and tire balance weights were outside the rim and not inside. I installed on OEM calipers which fit perfectly. If you have non EOM calipers, these cover will most likely not fit. They are specific to the OEM. Over all it took my 30 minutes to install properly. Instructions were included with diagram. No rubbing after install, and they look great even after a week of rain on them.

First you have to know that I never give a rating of 5 to anything on the 1st time because it doesn't leave room for something that is better. That being said my ratings for this product are very high. They look good on my vette!

So very little clearance that come next summer they will probably come off

Not the same as the powder coated caliper cover replacements - I think.The other ones are like $600 bucks or something - this is the cheaper alternative.Now I have to get them installed as I don't have a jack.I'm sure they'll look great. Fast shipping - Item as expected

kinda bigger than they should be. but, overall happy.

The look is good. I have a bit of a problem with the fit where I had to get BJs to relocate my wheel weights and they also sometimes squeak where the clip scrapes my rotors. In the instructions they say that might happen and the clips will need to be cut/filed down or some other way shortened, but this is just a pain. I wish the clips fit better from the start.

Had to do a little modification to fit, but looks great. Well worth it.

For what it is, it is too pricey, the letters of the logo seem painted by a kid, spotty, if they are gonna charge this much for something so simple, at least do it right, and GM shouldn't license products that are not up to standards at least in appearance.

Do not waste your $!Front ones do not fit on my C5 Vette, they rub on the rim. Talked to customer service with zero help!Terrible product, ended up spray painting calipers!

Great looking "add on" for car.

Nice . Makes the calipers stand out .Easy to install.