COMOWARE 10 inch Miter Saws Blade, 80T ATB Circular Saw Blade, 5/8" Arbor, TCT Carbide-Tipped, Anti-Vibration, Teflon Anti-Stick, Miter Saws Blades for Wood, Laminate, Plywood & Hardwoods

Smooth, clean cuts in aluminum. Blade will shave off a blade width without a problem. Excellent for producing exacting cuts.

Great value for the price works like any other blade that cost more

It cuts super cleanly for the first five cuts. But then it seems to be much duller for the next five. And still produces a good result, but a lot duller for the next five, requiring a lot more Force, and producing an edge that isn't perfectly clean if cutting too quickly.But cutting 1/8 in aluminum bar at 5 seconds per inch. Did a clean job, only producing slightly melted edge that could be broken off/wiped away with a leather glove.Wear please protection.The blade removes small chunks out of the aluminum, as well as fine shavings, hitting you in the face, getting in your hair, shoes, stinging your arms, and produces a large amount of debris, making a big mess several feet in every direction.But there is no vapor or odor, probably as a result of the shavings being so large, relative to sawdust when cutting wood with a wood blade.I'm still pondering why the blade dulled so quickly, even on soft aluminum, cutting so easily for the first couple of cuts, but it got to the point where it would grab the cut off material and throw it, if cutting faster, for example 1"/sec. This is with the material clamped down, which you always need when cutting soft metal.(For that, I used the DeWalt miter saw clamps.)

Works great on my Kobalt 10” mitre saw. I have been using this for about a month now and it is still cutting great. It hasn’t dulled or jumped while cutting and still cutting clean. As long as you temper your expectations and don’t expect a 60 or 80 dollar blade performance this will do just fine.

I have used this blade to cut several 1 and 1.25 inch aluminum round. Totally satisfied with the cuts and the blade. I am being careful in its use to make it last. Well pleased with the blade and timely delivery. Thank you.

Bought this blade to finish cut composite decking. Very nice finish cut, clears chips very well and stays sharp.

I like always having a very clean cut no matter what im saying even ripping plywood or cutting framing boards, so I always use finish blades in my circular saw.However, the name brands get expensive when you replace blades often.Decided to give this blade a try.Seems well made, installed perfectly, and gives a fast but buttery smooth cut.So far, im going to be going with this blade again in the future.

I recently installed about 550 square feet of wood flooring on the upper floor of my house and used this blade in my sliding compound miter saw to do the job; it remained sharp and made clean cuts through the whole job and I expect it to be sharp when I install floors in the lower/main level in the spring. I recommend it over similarly priced finish blades.I used it for cross grain cuts & ripping (cuts with the grain) of the flooring, as well as cutting the threshold transitions to length and it performed well in all scenarios.Flooring used on was prefinished 5/8" thick by 5" wide solid bamboo.If used for a home flooring install make sure you cut boards with the finish facing down as splintering may occur when the blade contacts the flooring.