Richeer 2 Inch 6x5.5 Hubcentric Wheel Spacers for Silverado Sierra 1500

Got these for my 2 wheel drive 2014 Silverado 1500. The hub centric lip was the perfect size, the metal was machined nicely, and the studs were the right size and threads. Took my time when installing and hand tightened everything with the supplied thread locker before torquing them to factory spec(everything has held good at 140ftlbs). Have had them on for about 100 miles and have been up to 85mph with no vibration or issues.

Nicely produced and packaged. Fit perfectly.

Very good quality for less than the competition

It was exactly what I ordered.

Installed them and they seem to be of good quality in my opinion. I will say that when tightening the lug nuts back on with the rim a good couple of them tended to keep spinning as I tightened. Which I found to be weird as I have not experienced that before on any other spacer I’ve used on my other car. Regardless I kept tightening with an impact and then finished off by hand. Will drive around for a few days and update if anything else happens. UPDATE: so far so good haven’t noticed anything being off besides increased vibrations at around 60-80 mph.

Been running over a year now on some 22inch rims wrapped in 35MT’s. Not a single issue. Would order again.

Easy installation, looks great

Prior to buying these wheel spacers I did my research and seen there were quite a few mixed reviews of the wheel studs snapping off. I installed these on my 21 GMC Sierra AT4. Torqued everything to 110 foot pounds in a crisscross pattern. I haven’t put an impact wrench on this. Everything has only been done with a manual torque wrench. on January 10, 2024. put 20 miles on the vehicle then retorqued everything to 110 foot pounds the next day January 11th. February 20, 2024. My wheels were making all sorts of racket. I have put only 1900miles on them since installing. I checked the torque and every single lug nut on my truck was loose. Haven’t encountered any studs snapping off yet. I’ve followed all steps needed for a correct install, But for them to already back off, almost completely has me worried that the tensile strength of the studs is not strong enough, and have potentially stretched. Concerning!! that if I go to retighten, they may snap off, or worse lose a tire while driving. 1.25 inch spacers 6x5.5 DO NOT RECOMMEND! thought saving a few bucks was going to be worth it but not when it comes to a $70,000 truck I will be going to name brand Bora. Hope this helps make up your mind. Just spend the extra money on better quality.

I cut around 5 mm from wheel stud to fit properly in front side but the back wheel doesn’t need to cut Spacers size 1.25 inch

Just installed today. Have not driven on them yet. Looks good will need to slightly trim lower bumper as I’m running 285/75/17.