2PCs Hood Lift Supports Compatible with 2011-2017 Chrysler 300, 2011-2017 Dodge Charger Front Hood Gas Charged Springs Struts Shocks Dampers 6558, SG314073

Granted, I’m leaving a review for these lift supports early on, but time will tell, as far as performance goes. One thing I already like: These lift the trunk higher than the stock lifts, which had me forever cracking my skull on the trunk latch!Installation is breeze; I had both replaced in under a minute.Just hope they last!

I have a 2005 Dodge Magnum. Hatch would fall after it was open for a short time. Replaced with these and WOW it almost opened by itself. And stays open. Very happy with this purchase. I read some of the one star reviews and think they did not have the knowledge to do the work.

These were easy to snap on surprisingly they were super stiff and made it hard to close the trunk lol but if you put in one at a time (keep one old one on and put a new one) close the trunk one to two times to break them in and you’ll be able to close the trunk with ease once you have them both installed.

put these on our 2011 challenger r/t with rear spoiler. after raising the deck lid about 6 inches the props take over with good force. hope these last half as long as the original ones. very good price.

I bought these for my 2010 Dodge Challenger which in the description says is compatible with. It is in fact not. I did use the instructions it came with and also watched a YouTube video. They are not the right size in result causing the product to break. I am requesting a product send back with refund.

Super happy, Installed them myself...I'm a girl...HA! They work so well on my Dodge Magnum that the liftgate opens by itself. Kinda hard to close now. The liftgate is really heavy too. love these...buy them, you won't be sorry.

Doesn’t fit this seller should not be selling warning they don’t fit 2016 charger way to big and about pop off the hood when you try and install this seller just wants your $ don’t even care that the product and description of car is supposed to fit doesn’t actually fit.

Not an exact fit on a 13 charger as some have said. Hook top of strut then place bottom over mount and a couple blows with a dead blow hammer and looks like they should work.

Just installed them on my 2006 Dodge Magnum lift gate. The installation was very quick, just push them on. They look like good quality and are very strong! You must hold the door from flying upwards to quicklyNow for the test of longevity…

These things are strong. You really only need one to hold the bonnet up. Very good quality.