12" Foldable Shelf Brackets Heavy Duty Stainless Steel Load: 132lb/60KG, Pack of 2

This is a pretty good product, and despite what some other reviewers say, it's pretty robust. I know because I had to modify it and it took ages to cut through the steel - so it must be pretty good quality.The slight design flaw is this: when you attach it to a wall with screws, there are holes cut in the angled strut to allow the crew heads to recess so the arm will close fully - so far so good. But the holes are not very big on the bottom end of the strut. On the end near the hinge no hole is needed as the sides of the arm sit either side. But likewise, the clearance is not very great. So if you use large screws with large heads (which you may if you need to use the full weight capacity of 60KG!) the screw heads will not fit through the recesses and the arm will not close.I was using bolts and they definitively did not fit through - hence my need to alter the design with a drill and a Dremmell.One other small point is that the pic is inaccurate. The levers which release the arm to allow it to lower are not near the end of the horizontal strut on the 14" version. It may be the pic is of a smaller size, and it's used for all. This may not be an important feature for you, but it was to me :-(.But if you have no special uses it should do the job fine.

I wrote previously but have had no reply. These brackets are unusable as there was far too much play on the hinge once installed so would not line up properly. They did not allow the table to lie flat against the wall when lowered due to interference from the supplied screws nor did they line it up horizontally in the upright position.

A little flimsy found it difficult to drill the holes for the screws as I have arthritis in my hands ,overall does the job for extra work space.

Good product.