Dorman 76833 HVAC Control Button Kit Compatible with Select Saab Models

These fit great and look/feel soooooo much better. My 2005 SAAB 9-3 needed a refresh, and these worked great. Just take your time, and when putting new buttons in I found it worked better to go top down in each row. That seemed to keep them seated better. Once you have them all in, the front face plate will secure them the rest of the way. 10/10 recommend. Before/after photos attached.

Perfect fit for my 2003 Saab 9-3 air conditioner panel. Time consuming yet simple install. Comes wirh heated seat buttons so you'll end up with some fakies if you dont have those

The BEST 13 bucks I have spent in a very long while. These are amazing quality and I wouldnt hesitate for a second to recommend these. Be advised of a few things: first, even though Amazon says it wont fit an Arc convertible, it WILL. PERFECTLY. Second, make sure that you carefully cut these from the sprue and clear any excess with a sharp blade. If you try to pop them off with your hands, you may end up breakong a button depressor. Third, I highly recommend installing the temp rockers on the sides first. You will see why once you get in there. If your Saab HVAC needs a refresh, you absolutely cannot go wrong with this... just go slow and be patient. It isnt difficult, but if you rush it, you may mess something up.

Replaced all my buttons since they easily wear., especially the AC one. Installation is very easy and take about 30min. All of them fit very well and there is no difference to OEM. Would buy it again if I have to.

As you can tell from the before and after these are a huge visual improvement. Install was slightly advanced for difficulty but most DIYers should be fine. The new buttons are clean and crisp allowing for the illumination to show well at night unlike the stickers that are out there. This is such a huge part of the dash that these buttons improve on a huge eyesore.

Surprisingly good quality for price, just don't force the LED pieces that come with it. they are tiny clear plastic meant to allow the car's LED's to light up thru them. they simply sit gently in the button just before you push the button into the car slot. be gentle - they work great. i only needed one button, so now have an entire set as needed.

They dont have the same soft feel as OEM buttons but they have been working well for me for a few weeks and I've forgotten the originals were different until I am writing a review. They went on easily, though I waa very careful. As you should be.I cant tell how long they'll last.

After years of looking at to old buttons with worn off paint it is great improvement. The new buttons WILL NOT scratch or wear away. When installing the new buttons be sure the top of each button slips under the tiny tabs so when you push on the tabs it has a rocker motion. If you don’t do this you will have to take it back apart and do it all over again.