Joywayus 5Pcs 1/4" Hose ID/Hose Barb 90 Degree L Right Angle Elbow Union Brass Fitting Water/Fuel/Air

Good quality and price, needed elbow that fitted 3/4 hose

works perfectly as a replacement for the plastic rx8 intake tubes

Perfect fit! A little expensive but good quality usually is.

Perfect 1/4'' elbow for my lawn tractors fuel line. Thank You Very much 5***** seller 5***** 1/4'' fuel elbow

Just what I was looking for. Perfect on all accounts. Right on time, shipping, and delivery!

These are what they say they are... 3/8" OD barbed x barbed brass elbows. I've used them in helping make sharper 90° turns in some condensate pump discharge line routing from my HVAC unit. Tight enough fit onto 3/8" ID vinyl tubing that was not as tight as other barbed fittings I've used before, but they hold and I expect no issues with the joint.

Good parts for making a hard 90 degree turn in your fuel line. I'm giving it 4 stars because it is a really tight fit and will give you some problems installing, especially if the line is on the vehicle. The good news is, once you push it on far enough and get a hose clamp on it, I doubt you will ever have to worry about it failing. In fact, after some actual use, you will probably have to cut the line get them free!

Nice quality pieces. Barbs nice and sharp to hold hoses almost don't need hose clamps. Found some of the local auto parts places don't carry pieces like this anymore since so many newer vehicles have specialty fittings and hoses. Worked perfect for my application.

The thing I most appreciated was that these fittings were exactly as expected, no disappointing surprises.

Good

Worked as expected.

Because this fitting uses multiple barbs, slipping the hose on just one end is difficult enough! I used silicone oil on both barb ends and even then, it was very difficult to push it together while under the vehicle. (At least with a multi-barb fitting, it has much less chance of falling off!) I had to install this fitting because my fuel injection hose was becoming kinked due to the angle it formed when connecting to my fuel filter. In hindsight, I would have installed this fitting when my fuel tank was off my vehicle - on the ground - since there is much more advantage when standing upright compared to lying underneath the fuel hose!

Fuel line repair