WANLIAN 170 Degree Soft Close Frameless Cabinet Door Hinges, 1 Pair

Put these on a "hidden" closet door and they work perfect. They have a slow closer bit closer tight. They are a little hard to install because they are stiff. However they are well built and been going strong for over a year now.

Used these for my crawlspace door. Easy to install and have worked well to hold the floor door open and not have to lift the whole thing. I like the way the hydraulic adjustable hinge moves so the door doesn't fall back when open. Super happy with the purchase.

It would have been smart to test them out on something first but I was impatient and was able to squeeze inside an opening and position them on the inside to mark where to screw the holes, which worked out well. I got these because I particularly wanted a hinge that would lift the top clear of the frame since my top extends beyond the sides of the frame. These hinges worked well and they are kind of beautiful in the design of the mechanism. I also adjusted the one obvious screw to change the maximum angle and that shortened it up a bit so it stays more vertical and outs less strain in the shed when open. Not a slow close, be aware.

Perfect for hidden floor hatch door. I was afraid these would be too flimsy bit they work great. I'm adding struts for the extra support. I wanted something that wouldn't bind when opening the hatch, but also close flush and this works perfect.

Those are great of great quality. However, don't use them for small doors. Unless you are working with some heavy doors, they are not the best to use. With small doors, you will have to put a lot of pressure to pull the door out as these tend to be really strong and have too much spring power. With heavier doors, the weight of the door overcomes the strengths and makes the operation of these hinges much smoother.

Good quality

Not bad to install, but couldn't hold up a helium balloon. I'm glad I did a test run before planning several other cabinets around them.

Hinges work great- pushing out a 1/2 inch to get around framework. A few people commented that it was difficult to position the hinge since there are no instructions and the hinge needs to be closed to position it properly. SOLUTION: All you need to do is use a small scrap of wood to get the location right. Once you have the hinge mounted on your base on that one side, copy the location on the other. Use the scrap lid to mark the position of the hinge on your actual lid. Just make sure the scrap of wood is small enough so you can close it whole way and still see the hinge.