Description
- HEAVY DUTY STAINLESS: This barn door handle was made of top quality stainless steel that is incredibly strong and sturdy. It can be efficient and durable for years to come. The strong stainless steel will never rust and it is corrosion resistant, so it can stay in the top condition even if it was putted outdoors in the rain and sun.
- EXTREMELY EASY TO INSTALL: Assembly is easy and you don not need to worry about wasting time and effort to figure out how to install the barn door handle. Two sizes installation hexagon wrenches as well as a complete backup accessory pack are included with a clear installation manual to finish the whole process effortlessly. Just drilling two holes in the door to combine the handle and finger pull with two screws.
- WIDE-RANG IN APPLICATION: Can be installed on any interior or exterior doors or with a variety of materials including glass, wood or aluminum doors. Use the barn door pull and flush set on wood, glass or aluminum doors. SEIDO handle can be used for interior or exterior doors, such as gate, shed, barn, garage, closet, sliding door.
- BEAUTIFUL FINISH & SATIN STAINLESS: Burnishing is a cost-saving protection way against corrosion. Multiple anti-corrosion layers extend product life expectancy to up to 15 years.
- PACKAGE CONTENTS: 1 Finger pull, 1 Pull handle, 2 Screws , 2 Pads, 2 Wrenchs
- ›See more product details
PRODUCTION DIMENSION Handle: 12 Inches Hole to Hole Distance: 7 1/8 Inches Cross Section Diameter: 1 5/8 Inches Finger Pull: L 8 5/8 Inches * W 2 5/16 Inches Door Panel Thickness/Diameter: 1 3/8 Inches and 1 3/4 Thick Barn Doors: Use longer 2 3/8 Inches screws for your thicker doors More detailed information please check the drawing. PACKAGE INCLUDED 1 * Bar Handle 1 * Finger Pull 2 * Pad 2 * Screws (Extra Long) 2 * L wrench NOTE: Large L Hex (For tighten the screw) Small L Hex ( For adjusting the tubes attached to the bar handle) INSTALLATION STEPS 1, Mark the holes on the door using the back plate. 2, Drill the holes. 3, Insert the screws through the back plate and the door. 4, Add the round mounting pads onto the screws on the front side of the door. 5, Use the allen wrench to screw the screws into the door handle.
